Dakota Digital LAT-NR221 User Manual

MAN#650209
Kit Includes:
Installation:
1. Remove the two screws and tail light lens.
INSTALLATION INSTRUCTIONS
LAT-NR221
LED Tail Lights for 1958 Chevy Bel Air/Biscayne and 1961-1967 Corvette
2. Remove the light bulb.
3. Push and twist to remove the plastic wire socket from the back side of the housing.
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended.
5. Remove the nut and round metal spacer from the back of the new LED assembly.
6. Insert the new LED assembly through the hole where the original bulb and connector were. Gently pull the wires through the opening to avoid damaging the wire insulation.
MAN#650209
7. Feed the wires through the round metal spacer, with one wire going through each outer hole in the aluminum spacer. Use caution when feeding wires through to avoid damaging the wire insulation. The larger diameter ring should be away from the tail light housing.
8. Secure the metal spacer with the supplied #6 nut.
9. Make sure the original lens gasket is in place and replace the tail light lens. Tighten the screws down carefully.
MAN#650209
Loading...
+ 1 hidden pages