Dakota Digital LAT-NR200 User Manual

INSTALLATION INSTRUCTIONS

LAT-NR200

LED Tail Lights for 1956 Chevy Car

MAN#650184

Kit Includes:

Installation:

1. Remove the two screws that are in the tail light lens, and
remove the lens.

2. Remove the light b

ulb.

P

3. ush and twist to remove the plastic bulb socket from the back side of the
housing.

4. ow is a good time to clean the lens and housing. If lenses are in bad shape a new set is

N
recommended.

5. , washer, and aluminum spacer from the back of the

Remove the nut
new LED assembly, noting how it is assembled for re-assembly.
Gently pull the wires through the aluminum spacer so the insulatio

n is

not damaged.

6. sert the new LED assembly, wires first, through the hole where the

In
original bulb and plastic socket were. Use caution when feeding the
wires through to avoid damaging the wire insulation.

MAN#650184

7. Insert the wires through the aluminum spacer, with one wire going
through each one of the outer holes. Ensure wires are not pinched to
avoid shorting! Slide the aluminum spacer over the stud thorough the
hole in the center of the spacer, shoulder side toward the back of the tail
light bezel.

8. Secure the aluminum spacer with the supplied #6 nut and lock washer.

9. Make sure the original lens gasket is in place and replace the tail light

lens. Tighten the screws down carefully.

MAN#650184