MAN#650176
Kit Includes:
Installation:
INSTALLATION INSTRUCTIONS
LAT-NR130
LED Tail Lights for 1965 Nova
1. Remove the tail light lens.
2. Remove the light bulb.
3. Remove the original bulb connector from the back side of the housing.
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
5. Remove the screw and aluminum back plate from the new LED assembly.
6. Insert the new LED assembly through the hole where the original bulb and connector were.
Use caution when feeding the wires through to avoid damaging the wire insulation.
7. Feed the wires through the large hole on the back plate. The flat side of the back plate should
be toward the outside and the side with the slightly raised center should go in toward the
housing. Guide the back plate onto the back side of the housing.
8. Secure the back plate with the supplied #6 screw and lock washer.
9. Make sure the original lens gasket is in place and replace the tail light lens. Tighten the
screws down carefully.