Dakota Digital LAT-NR111 User Manual

MAN#650170

Kit Includes:

Installation:

INSTALLATION INSTRUCTIONS

LAT-NR111

LED Tail Lights for 1969 Camaro

1. Remove the original bulb connectors from the bottom side of the housing.

2. Remove the plastic housing from the vehicle.

3. Remove the tail light lens by gently prying the housing away from the lens tabs.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.

5. Note that the screws and mounting plates are assembled differently for the driver side set and
passenger side set. The LED assemblies will sit in the housing at an angle similar to the back
side of the original lens.

driver side(screws and mounting plate offset to the left)

passenger side(screws and mounting plate offset to the right)

MAN#650170

6. Insert each new LED assembly through the hole where the original bulb and connector were
located. Use caution when feeding the wires through the socket opening to avoid damaging
the wire insulation.

7. Feed the wires through the large hole in the back plate and attach the
back plate onto the back side of the housing. The flat side of the
mounting plate should be toward the outside and the side with the
slight raised center should go in towards the housing. This will align
the mount in the original housing.

8. Secure the LED assembly into the housing with the supplied back plate and #6 lock nuts.

9. Place the original lens gasket into place and replace the tail light lens.

MAN#650170