Dakota Alert PR-2500 Owner's Manual
PR-2500
Portable
Receiver
Owner’s Manual
2.
CONTENTS
The PR-2500, battery charger, and belt clip. (gure 1)
Figure 1
WARNING
This device complies with Part 15 of the FCC rules, operation of this device is subject to the following conditions: 1. This device may not cause harmful interference. 2. This device must accept
any interference, including interference that may cause undesired operation.
INTRODUCTION
The PR-2500 receiver is compatible with all Dakota Alert 2500 and 3000 series transmitters. The
PR-2500 is capable of receiving and storing alert signals from four zones.
3.
When a signal is received, the zone will be displayed on the LCD screen and the receiver can be
set to give an audible tone or a silent vibrate alert. Each zone can store up to 400 events with a
time and date stamp or up to 999 events without a time and date stamp. The PR-2500 is powered by a rechargeable Li-Ion battery which will hold a charge for up to 10 days.
CHARGING THE PR-2500
To charge the PR-2500 plug the battery charger into an outlet and insert the jack into the charger plug (#5 on gure 2). The unit should be charged for 8-10 hours when the battery is low.
OPERATION
Push and hold the side button for two seconds to turn on the PR-2500. The unit will beep and
the time display will come on. Push and hold the side button to turn the unit o again. The
unit also has a backlight for viewing the display in low light situations. Pushing and releasing
any button will turn on the backlight for a few seconds. The backlight will also come on for a
few seconds when the PR-2500 receives an alert signal.
4.
THE PR2500
(Figure 2)
1. LCD display
2. (Side button)
ON/OFF
and Mode button
3. Left Button
4. Right Button
5. Charger plug
6. Reset button
1
3
4
2
5
6
Figure 2
Loading...