Dakota LAT-NR111 User Manual

MAN#650170

Kit Includes:

Installation:

INSTALLATION INSTRUCTIONS

LAT-NR111

LED Tail Lights for 1969 Camaro

1. Remove the original bulb connectors from the bottom side of the housing.

2. Remove the plastic housing from the vehicle.

3. Remove the tail light lens by gently prying the housing away from the lens tabs.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.

5. Note that the screws and mounting plates are assembled differently for the driver side set and
passenger side set. The LED assemblies will sit in the housing at an angle similar to the back
side of the original lens.

driver side(screws and mounting plate offset to the left)

passenger side(screws and mounting plate offset to the right)

MAN#650170

6. Insert each new LED assembly through the hole where the original bulb and connector were
located. Use caution when feeding the wires through the socket opening to avoid damaging
the wire insulation.

7. Feed the wires through the large hole in the back plate and attach the
back plate onto the back side of the housing. The flat side o f the
mounting plate should be toward the outsid e and the side with the
slight raised center should go in towards the housing. This will align
the mount in the original housing.

8. Secure the LED assembly into the housing with the supplied back plate and #6 lock nuts.

9. Place the original lens gasket into place and replace the tail light lens.

10. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires
from LED assembly to appropriate length once mounted, making sure wires are routed cleanly
and securely.

11. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED
assembly to the existing vehicle harness. Insert the appropriate wire from vehicle harness and
mating LED assembly wire into a connector and crimp following instructions below.

*For the best connection, soldering is recommended. But to simplify installation, the supplied connectors will

provide a fast weather resistant connection.

The correct crimp method for the supplied connectors is:

1.) Insert UNSTRIPPED wires into the connector and ensure they are all they way in by
observing the clear bottom of the connector to see the wires are touching the end.

2.) Use pliers to push the blue cap down flush with the edge of the clear body, completing the
connection. The connection will only be correct if pressed firmly down with pliers.

MAN#650170