Item Part Name Part Number
1 Handle 110
2 Retaining ring (National lock washer number XRC-327) 43965
3 3/8” –16 x 3/4” thumb screw 43622
4 Spindle 111
5 Retaining ring 67424
6 Ram (1” x 1” x 7 5/8”) 109
7 3/8”-16 x 5/8” headless set screw 43586
8 Brake spring 108
9 Tinners rivet 43577
10 Ram cap 103
11 1/4”-20 x 3/4” hex cap screw 43304
12 Ram cap shims (.008”) 106
13 Ram cap shims (.015”) 107
14 & 15 Table Plate assembly 700792
16 Frame 102
Please contact factory for current prices.
Ordering information: Please order all repair parts by part number and name, also mention model
number of press. All parts are shipped F.O.B. Factory in Grand Haven, MI.
Lubrication: Keep all working parts of the press well oiled for easier operation. Also keep a light film
of oil over the entire surface of the ram to prevent rust.
DAKE
Division of JSJ Corp.
724 Robbins Road
Grand Haven, MI 49417
Phone: 616-842-7110 800-937-3253
Fax: 616-842-0859 800-846-3253
E-Mail: customerservice@dakecorp.com
technicalservice@dakecorp.com
Website: www.dakecorp.com
9/10/03
SAFETY
This is the safety alert symbol. When you see this symbol on your press, be alert to the
potential for personal injury.
Follow recommended precautions and safe operating practices.
Carefully read all safety
messages in these
instructions and on your
press safety signs. Keep
safety labels in good condition.
Replace missing or damaged
safety labels.
This machine is intended
to be operated by one
person. This person should
be conscious of the press ram
movement not only for
themselves but also for persons
in the immediate area of the
machine.
Under no circumstances
increase the leverage
ratio of the press by using
a longer handle or by
placing a pipe over the
handle. Never hammer on top
of the ram.
9/10/03
Loading...