DAIKIN AC BRC2A71 User Guide

Quick User Guide

BRC2A71 Controller

BRC2A71

Changeover 12.

Current Operation Mode* 11.

Malfunction 10. Temperature 9.

Setpoint

Temperature 8.

Selection Buttons

* Auto changeover mode is not available with some Daikin Systems

1. Operation Light: Lit when system is on. Blinks in the event of a system malfunction.

2. Start operation with the ON/OFF button.

3. Centralized Control is indicated when the icon is displayed. Centralized Control is

only realized when an optional Daikin multizone controller is applied to the system.

4. Fan speed is displayed:

5. Defrost / Hot Start: Indicates that defrost or hot start is in progress.

The fan stops until the temperature of air supply rises enough at the beginning of a heating operation.

6. Fan Speed: Press to select High or Low fan speed.

7. Mode Selection Button: The five MODE icons indicate current operation mode. Select from:

H: high L: low

1. Operation Light

2. ON/OFF

3. Centralized Control

4. Fan Speed

5. Defrost / Hot Start

6. Fan Speed

7. Mode Selection Button

Heating switch automatically to maintain the desired setpoint temperature.

COOL Cooling Operation − To the

desired setpoint temperature.

HEAT Heating Operation − To the

desired setpoint temperature.

8. Temperature Selection Buttons: Use to set the required temperature setpoint. Each press up raises the set temperature by 1°F, pressing down lowers by 1°F. The temperature setting range is 60°F - 90°F.

9. Temperature Setpoint display.

10. Maintenance required: The wrench icon

service is required.

11. Current Operation Mode: These icons represent the current operation mode:

indicates a system malfunction and that

FAN Fan only operation (Room air is

circulated.)

DRY Cooling Operation − Unit operates

to minimize temperature change but reduces room humidity levels.

*AUTO Auto changeover (not available

with some Daikin Systems) - Cooling and

FAN DRY AUTO COOL HEAT

12. Changeover indicates that you cannot changeover heating/cooling with the remote controller. The absence of this icon indicates that the controller is designated as the changeover master with authority to change the system mode between heating & cooling. See details in the installation manual.

QUG-BRC2A71_10/08