Dahon WOBBEGONG SLING SACK Instructions Manual

The Dahon Sling Sack -

The simplest way to carry your Dahon Wobbegong

A B

A. Prepare your Wobbegong

Step 1.

slide the seat post to the lowest position. Fold
the pedals and protect the main tube of the
bicycle with the protective cloth included
with each bag. (see Fig. 1)

Fig. 1

Turn the handlebars 180degrees and

Step 2. Loosen the handlebar stem binder

screws on the stem with a 5mm Allen wrench.
(See Fig. 2)

B. Pack the Wobbegong in the Sling Sack

Step 1.

bag and unfold it.

Take the Sling sack out of its protective

Step 2. Open the autolock zippers, the head

and saddle straps. (Note: the zippers stay on
the derailleur side of the bicycle.

Step 3. Place the Sling Sack over the bike

allowing the seat post/saddle to protrude
from the upper bag opening. Secure the seat
post/saddle strap to prevent the bag from
dropping. This will allow you to handle the bag
more easily when fitting the wheels into the
bag. (See Fig. 4)

Fig. 2

Step 3. Make sure the removed stem and

handlebar are placed on the left (non-chain
wheel) side of the bicycle. (See Fig. 3)

Fig. 3

Fig. 4

Step 4. Fit the front wheel into the bag by

placing the front flap on the tire and then
rolling the bike forward. (See Fig. 5)

Fig. 5

©2008 Dahon | www.dahon.com/support/manuals.htm

Step 5. Fit the rear wheel into the bag by

placing the rear bag flap on the tire and
rolling the bike carefully backwards. Make
sure that the flap does not interfere with the

derailleur. (See Fig. 6)

Fig 6.

Step 6. Place the supplied cover on the stem

and place the stem/handlebar in the inside
pocket of the Sling Sack. Secure the stem/
handlebar strap and the hand grip.
(See Fig. 7)

Step 7.

autolock zippers/ (Double check the pull tab
of the zipper is in the “locked” position and
attach the shoulder strap. (See Fig. 8)

Fig. 8

Lower the side flap and zip the

Fig. 7

©2008 Dahon | www.dahon.com/support/manuals.htm