Daewoo RC-108 User Manual

AVCUUM CLEANER
OWNER'S MANUAL
Model No.: RC-108
READ AND SAVE THESE INSTRUCTIONS
Thank you for purchasing this vacuum cleaner.
For proper operation, please read this manual carefully before using.
DESCRIPTION AND USING
DUST METER
How to check the DUST METER! Operate the cleaner with MAX power and keep the wide suction brush apart from the floor.
• If the red indicator of the DUST METER appears, – Empty or change the dust bag. – In case the hose is blocked with a large object, remove it.
• When cleaning with the crevice tool or the dusting brush, the red indicator may appear. In this case, continue cleaning.
Button
WIDE SUCTION BRUSH
• Change the position of the button according to the surface to be cleaned.
POWE
• Connect to as shown o
• To plug or u plug itself. D pull on the
Hole Hook
HOSE HANDLE
Trouble shooting
Before Askig for Service, please check each item below first if you have any trouble with your cleaner.
Problem Check Point Measure
Suction power is weak
The cleaner does not work
Power cord will not rewind
• Dust bag
• Pipe or hose
• Power control switch
• Power cord
• Suction power
• When the dust bag is full or blocked or any of the accessories are blocked, the over-heating protection for the motor is activated.
• Power cord
If the dust bag is full of dust, empty it or change it for a new one. If clogged or blocked, remove obstructing object.
Make sure to set the power control switch to the curtain position. Check if power cord is plugged in. Check if hose is attached firmly into the suction hole. Switch off and unplug the cleaner and check the dust bag and accessoires and remove and blockage. The cleaner can be switched on again after about 20 minutes.
Pull the power cord out a little and press the cord rewind button.
3
Hose Holder
Hook
WER CORD
g or unplug, grasp the self. Do not hold or
CLEANING THE FILTER
• Open the cover. • Pull the filter out from the unit while lifting the gasket.
• After washing the filter with water, dry it completely.
• Insert again in the same position.
Bag Holder
Rubber
Slot
Hole
1
2
3
EMPTYING THE DUST BAG
• Open the dust cover and push the dust bag holder in the direction of the arrow and then take out the dust bag.
• Insert the dust bag board into slots and fit the hole of dust bag on the rubber hose while pushing the bag holder to the arrow. Then fix the dust bag by releasing the bag holder.
• The dust cover will not close completely when the dust bag is set wrong.
KEEPING
• Insert the pipe holder into the groove.
• Hang the hose hanger on the hook.
This vacuum cleaner should only be used for normal dry household dust and dirt. The manufacturer cannot be held responsible for any damage caused by the use or operation fo this cleaner contrary to these instructions. If the cleaner is wrongly operated for a purpose other than that for which it is intended, no liability cna be accepted for any possible damage.
PRECAUTIONS FOR SAFE USE
RED MARK
• Do not vacuum areas which contain moisture or water and flammable items needles, pins, razor blades, matches, cigarette-ends, etc., since they may damage the cleaner or dust bag.
• When rewinding the power cord, hold onto the plug before pressing the cord rewind button to prevent whipping.
• Do not pull the power cord out beyond the red mark.
• Make sure a dust bag and a motor protection filter are always inserted.
• Do not operate the cleaner if ; – the Power cord is damaged. – the hose shows visible signs of damage. It must be replaced by the manufacturer or a service agent or a similarly qualified person in order to avoid a hazzard.
Rating AC 230V 50Hz Watts NOM.: 1000W, MAX.: 1100W Dimensions 353 X 219 X 253 MM (D X H X W) Weight 4.2 Kg Cord length 5 m
Specifications
Loading...