Video out level(Unload) 75% color bar Vp-p 2.0±0.2 2
CD 1kHz/0dB/10K V 0.6±0.2 0.7
Audio out level
DVD 1kHz/0dB/10K V 2+0/-0.6 1.5
LINE OUT LEVEL 1kHz/0dB/10K V ≥2.8 3.6
20Hz dB ≤±3 0
FREQ RESP (DVD)
(20Hz~20kHz)
125Hz dB ≤±3 0
10kHz dB ≤±3 0
20kHz dB ≤±3 0
Signal-to-noise radio Infinity zere/-dB/L&R∝
dB ≥60 ≥60
Audio distortion&noise (DVD) 1kHz/0dB/L&R dB ≤-65 -65
Dynamic range (DVD) 1kHz/-60dB dB ≥85 ≥85
R/L Cross sound (DVD) 1kHz/0dB/L&R dB ≥45 ≥45
1kHz Channel unbalance 1kHz/0dB/L&R dB ≤3 0
Power Consumption Standby W ≤1 ≤1
DC 9V Rating W ≤12 ≤12
ECC Entircity A BEX TDV-552 um ≥100 100
Scratch A BEX TDV-541 mm ≥1.6 1.6
Black dot A BEX TDV-545 mm ≥ф0.8 0.8
Finger Print A BEX TDV-545 um ≥ф65 65
Vertical deviation A BEX TDV-533 mm ≥0.6 0.6
Note: Nominal specs represent the design specs. All units should be able to approximate these. Some will exceed
and some may drop slightly below these specs. Limit specs represent the absolute worst condition that might still
be considered acceptable. In no case should a unit fail to meet limit specs.
-3-
LCD
O
A
C
BLOCK DIAGRAM
DC T
R
G
B
SYNC
FRP
-13V
15V
5V
9V
7.5V
Y
9V
-4-
DVD
4332211DDCCBB
A
U
S TRACK
DRIVE
R
4
FE TE DRIVER
SPINDLE
5
SLED
A
5
-5-
GENERAL ALIGNMENT INSTRUCTION
The Main PCB of Monitor Modification:
1. Input voltage is 6.8V-16V, input signal is test circuit BY 5418.
2. Adjust VR1 to get horizontal phase shift and test point: 28.9MHz
3. Adjust VRB4 to get good performance..
The main PCB of DVD Modification:
1. Adjust the brightness to the brightest by VR, adjust video pattern’s color to white, test the screen
Brightness is 200±102 LUX.
With luminometer You can adjust R66 to get this standard.