F E ATURE CHART
Here are the features of your new refrigerator.
Take a moment to know all the features and convenience it was designed to provide.
Numbers match those in the illustration on page 1.
■
Ice tray
Fill tray 3/4 full to allow expansion of water during freezing. Place tray in freezer
chest. To release cubes, twist lid slightly.
■
Removable shelf
Shelves can be removed by pulling forward. The shelf can be placed at your
desirable position.
■
Freezer Shelf
To remove the freezer shelf!
1. Remove the screw on the left of inside freezer shelf with screw driver.
2. Push the shelf hooks to the back slightly and remove it by lifting off the slots of
bottom side.
3. Reverse procedure to install.
■
Defrost Drain V e s s e l
To remove defrost drain vessel.
1. Lift the defrost drain vessel slightly, then rotate bottom out and pull it down.
2. Reverse procedure to install.
FREEZER DOOR GASKET
FREEZER POCKET
FREEZER REMOVABLE SHELF
FREEZER TEMPERATURE
CONTROL KNOB
ICE TRAY
ICE BOX
REFRIGING-ROOM DOOR GASKET
EGG POCKET
REFRIGING-ROOM POCKET(SMALL
REFRIGING-ROOM POCKET(LARGE
LAMP COVER
REFRIGERATOR TEMPERATURE
CONTROL KNOB
REMOVABLE SHELF (LARGE)
GLASS SHELF
VEGETABLE BOX
CHILLED TRAY
)
)
1 2
■
Lamp Cover
To remove lamp cover
1. Push up the bottom ends of lamp
cover gently, then pull out.
2. Reverse procedure to install.
■
Vegetable Crisper
May be used for fruit and vegetable
storage. Both the crisper and its cover
shelf are removable for easy cleaning.
Simply slide forward to remove.
■
Egg Pocket
Egg supporter in this pocket can be
turned upside down.
May be used for small size goods.
M ETHODS OF SAFE INST A L LAT I O N
1. SAFE INSTALLATION PLACE FOR YOUR REFRIGERATOR
• Place the refrigerator
on hard and level
f l o o r.
• Place your refrigerator
where there is no heat
source nearby.
High surrounding
temperature will lower
cooling efficiency and
increases your
electricity bill.
• Place the refrigerator
in an area with low
m o i s t u r e .
Splashing water or a
high moisture area
may cause a short
circuit and make
rusting easier.
1. Check your voltage before inserting the power supply cord into the
socket.
2. Contact the earthing conductor to this unit with an attachment
earthing screw.
3. Don’t make it spill to this unit.
4. Don’t work with flammable spray, such as painting, near this unit.
5. Don’t put ignitable materials, such as benzine, L.P. Gas, alcohol,
etc., into this unit.
6. Precaution to the leakage of any gas equipment near this unit.
7. Precaution not to hold on to the door of this unit by children.
8. Precaution not to reinsert the power supply cord within 5 minutes
after release it from socket. If not, a trouble may be occured to
compressor.
3
• Avoid places that are
exposed to smoke.
The discoloring can
occur to the
r e f r i g e r a t o r.
• For good ventilation
place refrigerator with
the spaced specified
on the figure.
This helps cooling
e fficiency and lowers
the electricity bill.
4
• Placing the refrigerator
on the carpet may
cause heat to develop
and discolor the
appliance. In such a
case put a hard
wooden board or a
rubber mat between
the refrigerator and the
c a r p e t .