DAEWOO MW-700 User Manual

USER’S GUIDE

USER’S GUIDE

W

W

eb Monitor

eb Monitor

Model No : MW-700

1. Read all of these instructions.

2. Save these instructions for later use.

3. Unplug this monitor from the
wall outlet before cleaning. Do not
use liquid cleaners or aerosol clean­ers. Use a damp cloth for cleaning.

4. Do not use attachments not rec­ommended by the monitor manufacturer as they
may cause hazards.

5. Do not use this monitor near water, e.g., near a
bathtub, washbowl, kitchen sink, or laundry tub,
in a wet basement, or near a swimming pool, etc.

6. Do not place this monitor on an

unstable cart, stand, or table. The
monitor may fall, causing serious
injury to a child or adult, and seri­ous damage to the appliance.

7. Slots and openings in the cabi­net and the back or bottom are pro­vided for ventilation, to ensure
reliable operation of the monitor,
and to protect it from overheating.

These openings must not be
blocked or covered. The openings should never
be blocked by placing the monitor on a bed, sofa,
rug, or other similar surface. This monitor should
never be placed near or over a radiator or heat
register. This monitor should not be placed in a
built-in installation such as a bookcase unless
proper ventilation is provided.

8. This monitor should be operated
only from the type of power source
indicated on the marking label. If
you are not sure of the power sup­plied to your home, consult your
monitor dealer or local power com-

pany.

9. This monitor is equipped with a
3-wire grounding-type plug, That
is, a plug having a third (ground­ing) pin. This plug will only fit into

a grounding-type power outlet.
This is a safety feature. If you are unable to
insert the plug into the outlet, contact your elec­trician to replace your obsolete outlet. Do not
defeat the purpose of the grounding-type plug.

10. Do not allow anything to rest

on the power cord. Do not locate

this monitor where the cord will be

abused by people walking on it.

11. Follow all warnings and

instructions marked on the monitor.

IMPORTANT SAFEGUARDS

12. For added protection for this
monitor during a lightning storm,
or when it is left unattended and
unused for long periods of time,
unplug it from the wall outlet. This

will prevent damage to the monitor and/or the
computer due to lightning and power line surges.

13. Do not overload wall outlets and extension
cords as this can result in fire or electric shock.

14. Never push objects of any kind into this mon­itor through cabinet slots, as they may touch dan­gerous voltage points or short out parts that could
result in a fire or electric shock. Never spill liq­uid of any kind on the monitor.

15. Do not attempt to service this
monitor yourself, as opening or
removing covers may expose you
to dangerous voltages or other haz­ards. Refer all servicing to quali-

fied service personnel.

16. Unplug this monitor from the wall outlet and
refer servicing to qualified service personnel
under the following conditions:

a. When the power cord or plug is damaged or
frayed.

b. If liquid has been spilled into the monitor.
c. If the monitor has been exposed to rain or

water.
d. If the monitor does not operate normally by

following the operating instructions. Adjust only
those controls that are covered by the operating
instructions, as improper adjustment of other
controls may result in damage and will often
require extensive work by a qualified technician
to restore normal operation.

e. If the monitor has been dropped or the cabinet
has been damaged.

f. When the monitor exhibits a distinct change in
performance, this indicates a need for service.

17. When replacement parts are
required be sure the service techni­cian has used replacement parts
specified by the manufacturer that

have the same characteristics as the
original part. Unauthorized substitutions may
result in fire, electric shock, or other hazards.

18. Upon completion of any service or repairs to
this monitor, ask the service technician to per­form routine safety checks to determine that the
monitor is safe to operate.

FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT

NOTE : This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interfer­ence in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica­tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equip­ment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures :

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.

- Consult the dealer or an experienced radio or TV technician for help.

CAUTION : Any changes or modifications not expressly approved by the

party responsible for compliance could void the user

’s authority

to operate the equipment.

CANADIAN NOTICE

AVIS CANADIEN

This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.

Cet appareil numérique de la Class B respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.

Bitte lesen Sie alle diese Informationen, bevor Sie das Gerät in Betrieb
nehmen! Lesen Sie sich außerdem die Bedienungsanleitung komplett und
sorgfältig durch, da nur in diesem Fall eine problemlose Inbetriebnahme
erwartet werden kann.

• Achten Sie darauf, daß das Gerät nur in eine 230V Schuko-Steckdose

eingesteckt wird.

• Die Steckdose sollte jederzeit frei zugänglich sein um bei einem evtl.

auftretenden Notfall das Gerät schnell vom Netz zu trennen.

• Achten Sie desweiteren darauf, daß die Netzanschlußleitung nicht mech-

anisch beansprucht oder sonstwie beschädigt wird.

• Offnen Sie das Gerät niemals! Im Inneren befinden sich Teile mit

gefährlicher Spannung.

• Bevor Sie das Gerät reinigen, ziehen Sie bitte den Netzstecker aus der

Steckdose. Säubern Sie dann das Gerät mit einem feuchten (keinesfalls
tropfnassen) Lappen.

• Die in diesem Gerät entstehende Röntgenstrahlung ist ausreichend

abgeschirmt (Ortsdosisleistung in 0.1m Abstand weniger als 1.0µ Sv/h).
Beschleunigungsspannung maximal 29kV.

• Stellen Sie das Gerät an einem ergonomisch günstigen Ort auf und sor-

gen Sie dafür, daß der Monitor mit nach ISO 9241 -3, -7, -8 geprüfter
Peripherie betrieben wird, da nur unter diesen Umständen ein optimaler
ergonomischer Betrieb des Gerätes sichergestellt ist.

Falls Sie dennoch Fragen haben, auf die die Bedienungsanleitung keine hin­reichende Antwort geben kann, so kontaktieren Sie bitte den nächsten
Fachhändler.

Maschinenlärminformationsverordnung 3. GSGV, 18.01 1991:
Der arbeitsplatzbezogene Schalldruckpegel beträgt 70 dB (A) oder
wenigergemäß ISO 7779.

WICHTIGE INFORMATIONEN

DECLARA TION OF CONFORMITY

We, Manufacturer / Importer

DAEWOO ELECTRONICS CO., Ltd

541, 5-Ga , Namdaemoon-Ro , Jung-Gu , Seoul , Korea

declare under our sole responsibility that the product,

Web monitor

MW-700

to which this declaration relates is in conformity with
the following standard(s) or other normative document(s)

Safety : EN 60950/1992/A1:1993/A2:1993/

A3:1995/A4:1997

EMC : EN 55022/8.1994/A1:1995/A2:1997

EN 50082-1/1992
EN 61000 -3-2,3/1995

following the provisions of 89/336 EEC-EMC Directive
and the provisions of 73/23 EEC-Low Voltage Directive.

Handed over by : S.Lee, Director.

Display Business Division

2001, Seoul Signature:

S.Lee, Director.
Display Business Division.
DAEWOO ELECTRONICS Co., Ltd