3 4
Lamp cover
To remove the lamp cover
1. Push up the bottom end of lamp cover
gently , then pull out.
2. Reverse procedure to join together .
Vegetable case
May be used for fruit and vegetable storage.
Both the vegetable case and its cover shelf
are removable for easy cleaning. Simply slide
forward to remove.
Utility Pocket (T op)
The Egg Case in this pocket can be turned
upside down for the use of small size goods.
For lock installed refrigerators only.
CAUTION: 1. Check your voltage before inserting the power supply
cord into the socket.
2. Contact the earthing conductor to this unit with an
attachment earthing screw.
3. Do not spill liquid on this unit.
4. Do not use flammable spray, such as painting, near this unit.
5. Do not place ignitable material, such as benzine, L.P. gas,
alcohol etc., into this unit.
6. Take precautions against leakage of any gas equipment
near this unit.
7. Keep children from hanging on the door of this unit.
8. Do not reinsert the power supply cord within 5 minutes after
releasing it from the socket. If not, there may be problems
with the compressor.
CAUTION
When you put or take out food from the refrigerator, be careful not to hit
your head on the lock as there is a protrusion on the door of your
refrigerator.
METHODS OF SAFE INSTALLATION
• Place the refrigerator
on a strong and level
floor.
Unstable installation
can produce noise and
vibration.
• Place your refrigerator
where there is no heat
source nearby .
High atmosphere
temperature will lower
cooling efficiency and
increase your electricity
bill.
• Place the refrigerator in
an area where the
humidity level is low.
Splashing water on the
refrigerator or installing
the unit in a humid area
may cause short circuit
and rust.
• A void places that are
exposed to coal gas or
smoke, or discoloring
may occur on the
refrigerator.
• For good ventilation,
keep enough space
between the sidewalls
and your.
This helps to cool
efficiently and lowers
the electricity bill.
• Putting the refrigerator
on the carpet may
cause temperature rise
and result in the
discoloring of the
carpet due to the
compressor heat.
In such a case, place a
hard wooden board or
a rubber mat between
the carpet and the unit.