Daewoo GB21F1T2, GB20F8T2, GB14F8T1 User Manual

VIDEO AUDIO

STAND-BY POWER REC

REC

Instruction manual

Colour televideo

GB14F8T1 GB20F8T2 GB21F1T2

Please keep the video machine’s guarantee card and receipt safe for warranty purposes.

WORTH

knowing

Precautions

Read carefully through this manual to familiarise yourself with this highquality televideo. Make sure the rating of your household electricity supply matches that shown on the back of the televideo. Refer to this chapter and the “Initial installation” chapter (pages 4-9) to help you install and adjust your televideo.

Do not…

expose the televideo to high levels of humidity and heat, to avoid the risk of fire and electric shock. open the televideo. Have a qualified technician carry out repairs. connect the televideo to the power supply if you have just moved it from a cold to warm environment. This can result in condensation inside the recorder and cause serious damage to the machine and cassettes. Wait around two hours to allow it to reach room temperature.

Make sure…

the televideo is placed on a steady, flat surface. you place the televideo where there is good ventilation all around. you clean the televideo only with a soft, lint-free cloth; do not use aggressive or alcohol-based cleaning agents. (Unplug the set from the mains) you disconnect the power supply if the televideo appears to be working incorrectly, is making an unusual sound, has a strange smell, has smoke emitting from it or liquids have got inside it. Have a qualified technician check the televideo. you disconnect the power supply and aerial if you will not be using the televideo for a long period or during a thunderstorm.

The power cable must be fitted with a fused plug approved by ASTA or BSI to BS 1362 and provided with a 5A fuse. The fuse cover must always be securely replaced. If the televideo is not worikng, the fuse may need replacing (see also “Electrical Connection” on page 4). (U.K. Only)

For your own safety!

There are no components in this televideo you can service or repair yourself. Do not open the case of the televideo. Only allow qualified personnel to repair or service your set.

This televideo is designed for continuous operation. Switching it off does not disconnect it from the mains (stand-by). To disconnect it from the mains, you have to unplug it. Recording any copyright protected material may infringe a copyright.

NOTE : If the receiver is moved or placed in a different direction, the main power switch must be

switched off for at least 15 minutes in order to take out colour purity errors on the screen.

WORTH

knowing

Contents

Controls

The remote control unit

The televideo, On-screen display

Initial installation

Moulded plugs

Connecting up the televideo, Fitting the remote control’s batteries

Setting time and date

Tuning in stations, EDIT, Manual Tuning

8~10

Playing cassettes

Playing back

Still, Variable picture search, Continuous play

Recording cassettes

Simple recording, One touch recording (OTR)

Timer recording using VideoPlus+

When record time overlaps, Watching Programmes while recording

Normal timer recording

Timer Review-erasing or changing

18~19

More functions

Accessing the beginning of the next recording,Accessing the beginning of the previous recording, Resetting the counter to zero, Accessing counter zero position

Cassettes, V-Lock, Child Lock, Mute

Picture adjustments, picture type selection, Changing on-screen displays

Television timer, Snooze automatic

VideoPlus+ guide numbers

Teletext, teletext character set

Connections and copying

copying, Assembling

Scart socket

Appendix

Before you ask a specialist

Playing back, Simple recording, Auto tracking, One touch recording

Index, Technical data

Your product guarantee

31/32

On the following pages, the pictures show the buttons you press on the remote control to perform the function, and what you should see in the on-screen display or machine display (if present) VideoPlus+ is a trademark applied for by Gemstar Development Corp.. The VideoPlus+ system is manufactured under license from Gemstar Development Corporation.

Before doing anything with the televideo, please read the chapter “Initial installation”.

The remote control is the principle means of control, but the main playback and record functions are also available on the front of the machine.

Press the main power switch on the front panel to turn on the set, then press button.

CONTROLS

The remote control unit

TV stations-input sockets

To switch combined TV/video on and off (stand by) to reset the counter

to wind the cassette to counter position 0:00:00to

Record monitoring

(only 2Tuners Model), Auto tracking

to select on-screen displays Sound on/off

a button for selecting input sources for recording:

Volume up/down V-lock up/down

To select channels and adjust Manual tracking up/down Teletext page up/down

playback start/stop. pause while recording, still while playing back rewinding/fast forwarding a cassette from Stop, or picture search backwards/forwards from playback mode

the menu control. the controls for timer recording using the VideoPlus+ codes via on-screen display

Teletext on/off Teletext size

the record or OTR button (One Touch Recording means : each time you press the button recording is extended by 30 minutes)

FAVOURITE/NORMAL1/NORMAL2 a button that doubles the maximum recording time for

very long recordings (SP/LP) : (only U.K. Model) button for the sleep timer (press repeatedly)

max. 7 m

30˚ | 30˚

CONTROLS

The televideo

On-screen display

The televideo’s menu system gives you easy-to-understand access to the less used functions such as tuning to stations, clock setting and more.

The menus show you which button to press for the next step.

In addition, some other functions appear on screen if you want (press RECALL up to 3 times for on-screen displays).

Press the main power switch on the front panel to turn on the set, then press POWER( ) button.

NOTE : The combined TV/video close menus automatically after approx. 1 minute.

if no entry is made.

VIDEO AUDIO

STAND-BY POWER REC

REC

Video input Audio input

REC : Record

PLAY : Play

Indicator STAND BY : STAND BY(Red) POWER : Operation(Green) REC : Record(Yellow)

REW / FF: Rewind and Fast forward wind

STOP/EJECT: To stop and to eject the loaded cassette

VOLUME Down/Up Buttons PROGRAM Down/Up Buttons

MAIN POWER

SWITCH

HEAD

PHONE

Remote

sensor

MAIN MENU

PICTURE TV TIMER RECORD TIMER PRESET MISCELLANEOUS

SELECT ENTER

MENU EXIT

TV TIMER

01:01:1997 WED

TIME 02:30 ON TIMER 06:00 OFF PR 01 OFF TIMER 00:00 OFF

DATE

SELECT

MOVE CLEAR CLEAR MENU EXIT

01 ABCC

REW

– 0:01:33

example

For your own safety read the following instructions carefully before attempting to connect this unit to mains.

Initial

INSTALLATION

Moulded plugs

Should it be necessary to remove a moulded on plug from the mains cable, it should be cut off and replaced with a suitable replacement.

If the terminals in the plug are unmarked or you are in any doubt as to the correct connections, consult a qualified electrician.

The wires in this mains lead are coloured in accordance with the following code

Blue Neutral

Brown Live As the colour of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your replacement plug proceed as follows. The wire which is coloured blue must be connected to the terminal which is marked with letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with letter L or coloured red.

The moulded plug cannot be used for any other appliance, therefore remove the fuse and dispose immediately and safely to prevent anyone, especially children from plugging it in to a wall socket, which will create a safety hazard.

After replacement of the fuse in the moulded plug, the fuse cover must be refitted. If the fuse cover is lost a replacement cover must be obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the plug or the colour that is embossed in words in the base of the plug recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover.

Only 5 amp. replacement fuses which are ASTA approved to BS 1362 should be fitted. (U.K. Only)

We recommend the use of a good quality plug.

This symbol means that this unit is double insulated, an earth connection is not necessary.

Caution : To prevent electric shock, do not remove any covers.

Caution : No user serviceable parts inside, refer servicing to qualified service personnel.

Initial

INSTALLATION

Caution :

When operating this unit on 220-240V mains supply, please note that when the power switch is in the off mode, the unit is not disconnected from the mains supply. However, please be assured that it is perfectly safe to leave the unit connected to the mains supply.

Place your televideo

horizontally on a flat, steady base so that air can circulate around it for ventilation. away from humidity and heat, magnetic fields, such as those from loudspeakers etc., and with no heavy objects placed on top.

Initial

INSTALLATION

Connecting up the televideo

Fitting the remote control’s batteries

Switch off all components when connecting or disconnecting cables.

Plug the aerial cable into the “ANT” socket of the televideo. Make sure the rating of the household mains supply matches the rating

shown on the back of the televideo. Now plug in the mains lead.

Fit the batteries, size 1.5V AAA as shown above. Protect your environment by returning used batteries to your dealer. Since

batteries contain toxic substances they require special disposal methods. Make sure the batteries are always of the same type and age, and remove

them from the remote control if you are not using it for a long period.

Remove the battery cover on the reverse side of the remote control.

Install two barreries (“AAA” size) into the remote control.

Replace the battery cover.

The buttons to use are marked on the following pages.

Initial

INSTALLATION

Setting time and date

Switch your televideo on.

Call the televideo’s MAIN MENU.

Move the cursor down to the “TV TIMER”line. Confirm by pressing the ENTER/STOP button.

Set the numbers for the exact time and the correct date. Both the On timer and the off timer can be switched ON or OFF but both must be on to enable the timer to function.

DATE : dd/mm/yy TIME : Hour/Min

Store leaving “TV TIMER” Continue with the following page.

Mistake or change ?

Move curson to the position you wish to correct by using

/ / and RE-ENTER on

the remote control. If you do not set ‘DATE’ and ‘TIME’ menu, you can not set ‘on/off Timer’.

Timer controlled events require the exact time and the correct date.

Press the main power switch on the front panel to turn on the set, then press button.

MAIN MENU

TV TIMER RECORD TIMER PRESET MISCELLANEOUS

PICTURE

SELECT ENTER

MENU EXIT

MAIN MENU

PICTURE

RECORD TIMER PRESET MISCELLANEOUS

TV TIMER

SELECT ENTER

MENU EXIT

TV TIMER

01:01:1997 WED

TIME 02:30 ON TIMER 06:00 OFF PR 01 OFF TIMER 00:00 OFF

DATE

SELECT

MOVE CLEAR CLEAR MENU EXIT

01 ARD

Have handy a TV guide or newspaper to help you to identify the stations.

Initial

INSTALLATION

Tuning in stations

(If you see “AV” instead of “PR”, press the button)

If not on-screen, call the televideo’s “MAIN MENU”.

AUTOMATIC TUNING SYSTEM

Select the PRESET menu at the MAIN MENU. Place the cursor to “ATSS” with the up/down button.

Press the ENTER button until the tunning screen appears above the PRESET menu. The cursor will move from left to right on the VHF-L line, then VHF-H, then UHF. Please wait until the EDIT menu appears.

MAIN MENU

PICTURE TV TIMER RECORD TIMER PRESET MISCELLANEOUS

SELECT ENTER

MENU EXIT

ATSS SETTING

PR08 UHF

MENU EXIT

01 ARD

+ 26 hidden pages