: In this Manual, some parts can be changed for improving, their
performance without notice in the parts list. So, if you need the
latest parts information,please refer to PPL(Parts Price List) in
Service Information Center (http://svc.dwe.co.kr).
4. MACHINE ROOM VIEW AND PART LIST ................................................4
5. METHODS OF EXCHANGING MAIN PARTS ..........................................5
6. EXPLODE VIEW AND PARTS LIST .........................................................9
7. PARTS LIST .............................................................................................10
Page 3
1.Specification
Refrigerant
COOLING System
Refrigeration System
Defrost System
Defrost Operation
Cold Control
Capacity
R134a
Freezer
Refrigerator
Total
100g
Fan Cooling Convection Type
Air Forced Convection
Forced Fin-Evaporator Type
Automatic Start & Stop
Adjustable Dial
61L
207L
268L
External
Dimension
Net Weight
Height
Width
Depth
1636mm
600mm
729mm
57Kg
-1-
Page 4
2. NAME OF PARTS
-2-
Page 5
3. REFRIGERANT CYCLE DIAGRAM
-3-
Page 6
4. MACHINE ROOM VIEW AND PART LIST
NOPART NAMENOPART NAMENOPART NAME
1BASE CAB AS7WI-CON PIPE13 BASE COMP AS
2COMPRESSOR8DRYER AS14 BRACKET EARTH
3P-RELAY AS9PIPE SUC AS15 POWER CORD AS
4PIPE VAPORI AS10 PIPE SUC CONN16 ABSORBER PIPE A
5ABSORBER PIPE B11 BOX POWER AS
6PIPE HOT12 HARNESS EARTH
-4-
Page 7
5. METHODS OF EXCHANGING MAIN PARTS
(1) Freezing room louver
1) Unscrew, remove the F-louver by
pulling forward with inserting
screwdriver into the hole of F louver.
2) Assemble it by pressing triangle
shape ( ) by hand.
(2) R control box
1) After pressing both bottom surfaces
of shade and pull forward.
2) To exchange the interior lamp,
unscrew the lamp counterclockwise.
3) Remove two screws
-5-
Page 8
Methode of exchanging main parts
4) Pull slightly forward with instant force.
5) Remove the housing
6) After romoving the control switch knob
and two screws for fixing control switch,
change the control switch to new one.
-6-
Page 9
Methode of exchanging main parts
(3) Bimetal
1) Cut off the wire bind.
2) Take out the bimetal.
(4) Glass tube heater
BIMETAL
1) Remove 2 screws that fasten the evaporator.
2) Slightly pull the evaporator to the arrow's
direction.
3) Move the entire eveporator upward the pipe
center to the arrow's direction.
Evaporator fastening screw
(Do not crumble the part A of the
accumulator during the process.)
-7-
Page 10
Methode of exchanging main parts
4) Cut the both ends of glass tube heater tube
heater lead wires and insulate and seal lead
tip remaining in refrigerator with tape etc.
Raise
5) Pull out the glass tube heater from the heater
supporter with heater covers remaining.
(upper and lower) (Do not apply much
power on the heater supporter.)
6) Install the heater covers (upper and lower)
on a new glass tube heater. (Make the cover
with holes the lower one)
Heater
Cover
Heater Cover
(Bottom)
Glass tube
Heater
heater
Lead wire
Heater Cover
(Top)
Heater
Cover
7) Place the glass tube heater lead wire shown
as below and fasten the shaded area with
type.
8) Fin insert the lead wire connection terminals.
(Same colored lead wires)
9) Set the evaporator on normal position and
secure the fastening screws.
-8-
Frontsid
AL
Lead
Glass tube
Page 11
6. EXPLODE VIEW AND PARTS LIST
1. Expoloded viewsSPAIN DESPA (DAEWOO,FR-330)
Page 12
✔ Caution:
In this Service Manual, some parts can be changed for improving, their performance without notice in the parts list. So, if you need the
latest parts information, please refer to PPL(Parts Price List) in Service information Center(http://svc.dwe.co.kr)
463012624000HANDLE F AABS1A TYPE
473011610810DECO F HNDL AS1A TYPE
483019015700POCKET F *TGPPS1
493019015800POCKET F *UGPPS1
50-ASSY R DOOR URTHCFC-141B1
513012310010GASKET R DR ASPVC-S1
523019016200POCKET SMGPPS1
53
543011165700CASE EGGGPPS2
553019015900POCKET EGGGPPS1
563019016000POCKET MULTGPPS2
573019016100POCKET BOTLGPPS1
583012624200HANDLE R AABS1A TYPE
593011611110DECO F HNDL AS1A TYPE
60
617112401211SCREW TAPPINGT1 TRS 4X12 MFZN4
7002501611SCREW MACHINETRS 5X16 MFZN4
3014443500PIPE WI-CON ASFR-3301
-11-
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.