F E ATURE CHART
ICE HOLDER ASSEMBLY
F SHELF (MOVA B L E )
FREEZER TEMPERATURE CONTRO L
K N O B
ICE CASE FRAME ASSEMBLY
CHILLED CASE
LAMP COV E R
R E F R I G E R ATOR TEMPERAT U R E
C O N T ROL SWITCH
R SHELF (MOVA B L E )
V E G E TABLE CASE COV E R
V E G E TABLE CASE
FREEZER POCKET
FREEZER POCKET
UTILITY POCKET
EGG CASE
B OTTLE POCKET(LARGE)
B OTTLE POCKET(SMALL)
1
Here are the features of your new refrigerator.
Take a moment to know all the features designed for your conv e n i e n c e.
M ov e ble Refrigerator and Freezer Shelves
S t o rage shelves should be adjusted depending on the height of the food stored. To do this, pull
the shelves slightly fo r wa r d .
D e f rost-drain Ve s s a l
Dust acoumulated in the drain case decreases the eva p o ration efficiency. You should clean the
d rain case at regular interva l s.
Ice Case Frame Assembly
1) Fill the ice case with water up to the water level line and insert it into the designated space in
the ice holder.
2) After the water is completely frozen, twist the ice case handle clockwise and let the ice fall into
the ice box below, When all ice has been cleared from the ice case, let go of the handle which
will return to its orlginal position by an installed return spri n g .
S TA RTING POINT OF TWISTING
2
Lamp cov e r
To remove the lamp cove r
1. Push up the bottom end of lamp cover gently, then
pull out.
2. R everse procedure to join together.
Ve ge t a ble case
M ay be used for fruit and ve g e t a ble stora g e. Both the
ve g e t a ble case and its cover shelf are remova ble fo r
easy cleaning. Simply slide fo r ward to remove.
Utility Po cket (To p )
The Egg Case in this pocket can be turned upside
d own for the storage of small size goods.
C AU T I O N : 1. Check your voltage before inserting the power supply cord into the socke t .
2. Connect the earthing conductor to this unit with an attachment earthing screw.
3. Do not spill liquid on this unit.
4. Do not use flammable spray, such as spray paint, near this unit.
5. Do not place ignitable material, such as benzine, L.P. gas, alcohol etc., into this
u n i t .
6. Ta ke precautions against leakage of any gas equipment near this unit.
7. Keep children from hanging on the door of this unit.
8. Do not reinsert the power supply cord within 5 minutes after removing it from the
socket. If not, there may be problems with the compressor.
For lock installed refrige r a t o rs only.
C AU T I O N
When you put or take out food from the refri g e ra t o r, be careful not to hit your head on the lock
as there is a protrusion on the door of your refri g e ra t o r.
3
METHODS OF SAFE INSTA L L AT I O N
1. SAFE INSTALLATION PLACE FOR YOUR REFRIGERATOR
• Place the refri g e rator on a
strong and level floor.
U n s t a ble installation can
produce noise and
v i b ra t i o n .
• Place your refri g e ra t o r
where there is no heat
source nearby.
High ex t e rnal tempera t u r e s
will lower cooling efficiency
and increase your electri c i t y
b i l l .
• Place the refri g e rator in an
area where the humidity
l evel is low.
Splashing water on the
r e f ri g e rator or installing the
unit in a humid area may
cause a short circuit and
ru s t .
• Avoid places that are
exposed to coal gas or
s m o ke, as discolouring may
occur on the refri g e ra t o r.
• For good ventilation, ke e p
enough space between the
s i d ewalls and yo u r
r e f ri g e ra t o r.
This helps to cool efficiently
and lowers the electricity bill.
• Putting the refri g e rator on
the carpet may cause a
t e m p e rature rise and result
in the discolouring of the
c a rpet due to the
compressor heat.
In such a case, place a hard
wooden board or a ru bb e r
mat between the carpet and
the unit.
4