Daewoo FR-054R, FR-084R, FR-136R User Manual

21

NAMES OF THE PARTS HOW TO OPERATE

Starting your new Refrigerator

1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the
interior with a clean moist cloth.

2. Insert the power supply cord into the socket.

3. Turn the thermostat dial to “7”. Close the door and let the refrigerator
operate for 15-20 minutes.

T emperature control

To control the internal temperature, adjust
the thermostat dial. The dial is numbered
from 1-7.
Number 1 is the warmest setting, number 7
the coldest.
The dial may be set any place on the
scale.
It does not have to be set exactly on a
number. To make ice cubes in the chiller
compartment, adjust the thermostat to the
coldest setting.
Note-the bar fridge will only make ice with
the aluminium ice tray provided.

How to defrost

Defrost the refrigerator when the frost accumulated on the evaporator is
about 5mm (1/5inch) thick.
Set the thermostat dial to “OFF”. Keep drip tray in place. Defrosting usually
takes a few hours. To defrost quickly remove all goods from the refrigerator
and leave the door open. Never use a knife or other metal instrument to
scrape ice/frost from the freezer. After defrosting, empty water from drip tray
and return the thermostat dial to the desired position.

NOTE: Wait 3-5 minutes before restarting if you unplug the refrigerator.

The unit may fail to operate properly if restarted too quickly .

! Freezer
@ Drain Pan
# Control Box
$ Shelf
% Magnetic Door Seal
^ Ice Cube T ray
& Rack
* Bottle Rack
( Crisper
) Slide out crisper cover

FR-054R

FR-136R

FR-084R

4

WHAT TO DO...

When you do not use the fridge for a prolonged period:

• Remove the power plug from the power point.

• Remove all contents from the fridge.

• Dry the interior and leave the door open for a few days.

When you wish to move the fridge:

• Secure all movable parts and contents.

(Package them separately if necessary .)

• Transport the fridge only in an upright position. In any other position you

may damage the compressor.

Before calling service, please follow the checklist below.
This may save you an expensive service call.

If the refrigerator seems too warm inside:

• Check that the door has not been opened too frequently or for too long.

• Check that the interior circulation is not obstructed by having too many

goods stored. (The fridge is overloaded)

• Did you store anything hot, without first cooling it to room temperature?

• Is there sufficient clearance around all sides and above the fridge?

If the fridge starts making any unusual noises:

• Is it wobbling? Re-level it and check if it now operates normally .

• Have any objects fallen behind the fridge? If so, remove them and check if

operation is now normal.

• Are any containers inside the fridge vibrating or resonating? If so, rearrange

them then check to see if operation has returned to normal.

3

HOW TO CLEAN

Cleaners : Never use harsh, abrasive cleaners, heavy-duty cleaners, or

solvents on any surface.

Exterior : Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains

and for periodic waxing, use silicon wax.

Chiller : When refrigerator needs defrosting turn thermostat dial to “OFF”.

Do not use sharp instruments to scrape off ice/frost.

Refrigeration Section: Wash shelves and other removable parts in warm

sudsy water, rinse and dry. Wash interior with baking soda
solution (3 Table spoons to 1 Liter of water) or warm sudsy water,
rinse and dry .

Magnetic Door Seals: Wash with warm sudsy water .
The Finishing Touch: Replace all parts and return thermostat dial to

desired setting.

HOW TO INSTALL

󱇲 Install refrigerator in a convenient location away from extreme heat and

cold. Allow sufficient clearance between the refrigerator and side wall so
the door may open fully without obstruction.
Refrigerator is not designed for recessed
installation.

󱇲 Select a space with a strong level floor .
󱇲 Allow 10cm space between the refrigerator

and all walls.

󱇲 If installing into a cabinet, ensure you have

good ventilation.

󱇲 The electrical plug must be accessible without

moving the set.

CAUTION:

1. If the supply cord becomes damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid a hazard.

2. The appliance is not intended for use by young children or infirm
persons without supervision.

3. Young children should be supervised to ensure that they do not
play with the appliance.