NAMES OF THE PARTS
! FREEZER
@ DRAIN P AN (Use for Defrost Only)
# CONTROL BOX
$ PLASTIC COA TED SHELF
% MAGNETIC DOOR SEALS
^ BOTTLE RACK
& BOTTLE RACK
* BOTTLE RACK FOR BOTTLES CAN OR JARS
081 NEC (FR-083) 01.5.3 12:24 PM ˘`1
2
HO W TO OPERATE
Starting your new Refrigerator
1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the
interior with a clean moist cloth.
2. Insert the power supply cord into the socket.
3. Turn the thermostat dial to “7”. Close the door and let the refrigerator
operate for 15-20 minutes.
T emperature control
To control the internal temperature, adjust
the thermostat dial. The dial is numbered
from 1-7.
Number 1 is the warmest setting, number 7
the coldest.
The dial may be set any place on the
scale.
It does not have to be set exactly on a
number. To make ice cubes in the chiller
compartment, adjust the thermostat to the
coldest setting.
Note-the bar fridge will only make ice with
the aluminium ice tray provided.
How to defrost
Defrost the refrigerator when the frost accumulated on the evaporator is
about 5mm (1/5inch) thick.
Set the thermostat dial to “OFF”. Keep drip tray in place. Defrosting usually
takes a few hours. To defrost quickly remove all goods from the refrigerator
and leave the door open. Never use a knife or other metal instrument to
scrape ice/frost from the freezer. After defrosting, empty water from drip tray
and return the thermostat dial to the desired position.
NOTE: Wait 3-5 minutes before restarting if you unplug the refrigerator.
The unit may fail to operate properly if restarted too quickly .
081 NEC (FR-083) 01.5.3 12:24 PM ˘`2
C
6
7
OFF
1
CONTROL DE
TEMPERATURE
5
4
3
2
O
L
D
E
R
3
HO W TO CLEAN
Cleaners : Never use harsh, abrasive cleaners, heavy-duty cleaners, or
solvents on any surface.
Exterior : Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains
and for periodic waxing, use silicon wax.
Chiller : When refrigerator needs defrosting turn thermostat dial to “OFF”.
Do not use sharp instruments to scrape off ice/frost.
Refrigeration Section: Wash shelves and other removable parts in warm
sudsy water, rinse and dry. Wash interior with baking soda
solution (3 Table spoons to 1 Liter of water) or warm sudsy water ,
rinse and dry .
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return thermostat dial to
desired setting.
HO W TO INSTALL
§ Install refrigerator in a convenient location away from extreme heat and
cold. Allow sufficient clearance between the refrigerator and side wall so
the door may open fully without obstruction.
Refrigerator is not designed for recessed
installation.
§ Select a space with a strong level floor.
§ Allow 5 inches of space between the
refrigerator’s side and the wall.
CAUTION:
1. If the supply cord becomes damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to aboid a hazard.
2. The appliance is not intended for use by young children or infirm
persons without supervision.
3. Young children should be supervised to ensure that they do not
play with the appliance.
081 NEC (FR-083) 01.5.3 12:24 PM ˘`3
5
inches