Daewoo FR-083 User Manual

NAMES OF THE PARTS

! CHILLER @ DRAIN PAN (Use for Defrost Only) # CONTROL BO X $ PLASTIC COATED SHELF % MAGNETIC DOOR SEALS ^ BOTTLE RA CK & RACK * EGG SHELF

HO W TO OPERATE

Starting your new Refrigerator

1. Clean the refrigerator thoroughly. Wipe the outside with a soft dry cloth, the interior with a clean moist cloth.

2. Insert the power supply cord into the socket.

3. Turn the ther mostat dial to “7”. Close the door and let the refrigerator operate for 15-20 minutes .

T emperature control

To control the internal temperature, adjust the thermostat dial. The dial is numbered from 1-7. Number 1 is the warmest setting, number 7 the coldest. The dial may be set any place on the scale. It does not have to be set exactly on a number. To make ice cubes in the chiller compartment, adjust the ther mostat to the coldest setting. Note-the bar fridge will only make ice with the aluminium ice tray provided.

How to defrost

Defrost the refrigerator when the frost accumulated on the evaporator is about 5mm (1/5inch) thick. Set the thermostat dial to “OFF”. Keep drip tray in place. Defrosting usually takes a few hours. To defrost quickly remove all goods from the refrigerator and leave the door open. Never use a knife or other metal instrument to scrape ice/frost from the freezer. After defrosting, empty water from drip tray and return the thermostat dial to the desired position.

NOTE: Wait 3-5 minutes bef ore restarting if you unplug the refrigerator .

The unit may fail to oper ate properly if restarted too quickly.

OFF

CONTROL DE TEMPERATURE

WHAT TO DO...

When you do not use the fridge for a prolonged period:

• Remove the power plug from the po wer point.

• Remove all contents from the fridge.

• Dry the interior and leave the door open for a fe w da ys .

When you wish to move the fridge:

• Secure all movable parts and contents.

(Package them separ ately if necessary.)

• Transport the fridge only in an upright position. In any other position you

may damage the compressor .

Before calling service, please follow the chec klist below. This may sav e you an e xpensiv e service call.

If the refrigerator seems too warm inside:

• Check that the door has not been opened too frequently or for too long.

• Check that the interior circulation is not obstructed by having too many

goods stored. (The fridge is overloaded)

• Did you store anything hot. without first cooling it to room temperature?

• Is there sufficient clearance around all sides and above the fridge?

If the fridge starts making any unusual noises:

• Is it wobbling? Re-le v el it and check if it no w operates normally.

• Have any objects f allen behind the fridge? If so remo ve them and chec k if

operation is now normal.

• Are any containers inside the fridge vibrating or resonating? If so, rearr ange

them then check to see if operation has returned to normal.

HO W TO CLEAN

Cleaners : Never use harsh, abrasive cleaners, heavy-duty cleaners, or

solvents on any surf ace.

Exterior : Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains

and for periodic waxing, use silicon wax.

Chiller : When refrigerator needs defrosting turn thermostat dial to “OFF”.

Do not use sharp instruments to scrape off ice/frost.

Refrigeration Section: Wash shelves and other removable parts in warm

sudsy water, rinse and dry. Wash interior with baking soda solution (3 Table spoons to 1 Liter of water) or warm sudsy water, rinse and dry.

Magnetic Door Seals: Wash with warm sudsy water. The Finishing Touch: Replace all parts and return ther mostat dial to

desired setting.

HO W TO INSTALL

§ Install refrigerator in a convenient location away from extreme heat and

cold. Allow sufficient clearance between the refrigerator and side wall so the door may open fully without obstruction. Refrigerator is not designed for recessed installation.

§ Select a space with a strong level floor.

§ Allow 5 inches of space between the

refrigerator’s side and the wall.

§ The electrical plug must be accessible without

moving the set.

CAUTION:

1. If the supply cord becomes damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to aboid a hazard.

2. The appliance is not intended for use by young children or infirm persons without supervision.

3. Young children should be supervised to ensure that they do not play with the appliance.

5 inches

+ 1 hidden pages