Daewoo DW-444PA User Manual
DW-444PA 00.4.26 11:8 AM
PARTS IDENTIFICATION
Rub-Wash Section
Drain Selector (Pump Control Switch)
Overflow Strainer
Drain Strainer
Wash Action Selector
Wash Timer Switch
(15 min. timer)
Water Inlet Port
Wash-Tub Lid
Wash Tub
Agitator (with Lint-filter)
Spin-tub Lid
When this lid is opened, the spin dryer
immediatelystops operating
Spin Timer Switch (5 min. timer)
Inner Lid of Spin-dry Tub
Prevent your hands, etc.,
from touching the spin-dry
basket in rotation
Power Cord
Spin Tub
Power Cord Rack
Panel Front
Drain Hose Assembly
(NON-PUMP)
Accessories
Drain Hose Assembly (PUMP)
Safety Cover
Lint Filter
INSTALLATION
Electrical Connection
In case of 3-core cord: The power plug must be connected to an earthed 3-pin power point
within reach of the power cord.
In case of 2 conductor power cord: Connect the grounding wire to a water faucet etc. Make sure
that the power cord is unplugged during ground work.
Connection of Hoses
Attach the drain hose to the drain outlet at the left side of
Figure 1.
the under base and secure with the clamp provided.
Hang the "U" Shaped outlet of the drain hose on the
edge of a sink.
Attach the water inlet hose to the water inlet located at
the left-hand side of the control panel. Press fit the other
end of the hose to either a hot or cold water tap as
required (Fig. 1).
WATER INLET PORT
Place of installation
Choose a place on a horizontal solid floor. If the machine is installed on an unstable floor, heavy
vibration will result during spin.
1
2
OPERATING INSTRUCTIONS
Preparing the Wash
Use a 3-pronged
plug
Sort the clothes into groups-whites, colourfast, non-colourfast, delicates, lint free, lint producers,
etc., and wash according to the Washing Guide below.
Clothes with worn patches or tears should first be mended. Empty out all
pockets and close all slide fasteners. Treat bad stains prior to washing.
Prior to Washing
Remove the plastic spin mat from the spin bowl.
Check that the wash timer knob is set to position "0" and that the drain selector is set to "wash
rinse".
Also check that the lint filter is correctly positioned.
Ensure the drain hose is in its correct position (see lnstallation).
Insert the power plug into the power point and switch on.
To Wash
Place the wash load and detergent in the wash tub. Refer to "Preparing the Wash" and "Points to
Remember"
Set the drain selector to "wash-rinse"
Turn the water tap on and fill the tub of your washing machine to the level recommended in
the Washing Guide.
Set the selector switch to the position recommended in the Washing Guide.
DRAIN HOSE SETTING
(1) Connect the drain hose to the drain outlet at the rear side of
your washer, and then fasten it tightly with the hose clamp.
(2) The other end of the drain hose should be set toward the
bath or sinkhole.
(3) Install the drain hose about 85cm from the ground.
(In case of drain pump model)
OPERATING INSTRUCTIONS
Set the wash timer to the wash period recommended in the Washing Guide.
Your machine will now wash for the period selected.
When the wash period expires, set the drain selector to the drain position to discharge the water.
to discharge the water.
Note: Before rinsing, the wash load may be transferred to the spin bowl to spin dry for 1
minute (approx.) to remove excess suds (see Spin Drying). On completion, transfer the
wash load to the wash tub for rinsing.
Hose Clamp
Drain Outlet
Drain hose
A
GROUNDING INSTRUCTION
Warning: Improper use of the grounding plug can result
in a risk of electric shock. Consult a qualified
electrician or serviceperson if the grounding
instructions are not completely understood, or
if doubt exists as to whether the appliance is
properly grounded.
If it is necessary to use an extension cord, use
only a three wire extension cord that has a three
blade grounding plug, and a three slot receptacle
that will accept the plug on the appliance. The
marked rating of the extension cord should be
equal to or greater than the electrical rating of
the appliance.
This appliance must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current.
This appliance is equipped with a cord having a grounding wire with a grounding plug.
The plug must be plugged into an outlet that is properly installed and grounded.
3-pronged plug
3 pronged
Receptacle
Receptacle
Box Cover
DW-444PA 00.4.26 11:8 AM ˘`2
Loading...