Daewoo DW-3610 User Manual
1
NAME OF P AR TS
7
%
$
#
@
!*
1
(
)
2
3
4
5
8
6
^
&
! Wash Timer
@ Select Switch
# Water Inlet Port
$ Washer Lid
% Washer Tub
Accessories
7 Spin Mat
^ Strainer
& Pulsator
* Valve Selector
( Spin Dryer Timer
) Spin Dryer Lid
8 Drain Hose Assembly
1 Inner Lid
2 Overflow Filter
3 Spin Dryer Drum
4 Base Under
5 Power Cord
6 Leg (4EA)
2
INST ALLATION
Electrical Connection
• This unit is designed to operate from an adequate supply mentioned at the
rating label sticked to the rear of it.
• In case of 3-core cord: The power cord plug must be connected to an earthed
3-pin power point within reach of the power cord.
• In case of 2 conductor power cord: Connect the grounding wire to a water faucet etc. Make sure that the power cord is unplugged during ground work.
• Do not connect the grounding wire end to a gas tube.
• If the power cord is damaged, it should be replaced by a repair shop appointed
by the manufacturer, because special purpose tools are required.
Connection of Hose
• Attach the water intake hose to the
Water inlet located at the left-hand
side of the con-trol panel. Press fit the
other end of the hose to either a hot
or cold water tap as required. (Fig. 1).
• Attach the drain hose to the drain outlet at the rear of the base and secure
with the clamp provided.
• The drain hose should be laid flat on the ground. Water flow will be restricted
if any portion of the drain hose is raised 20 cm (8 in) from the ground.
• The opening must not be obstructed by carpeting when the washing machine
is installed on a carpeted floor.
Caution: This unit is made of poly
propylene, use water below 50°C.
WATER INTAKE HOSE
WATER INLET
Figura 1.
HOW TO OPERATE
1. Wash
§ Insert the power plug into a wall
socket.
§ Set the selector at WASH AND
RINSE, and fill up the washer with
enough water for the washing load.
§ Put in the proper amount of detergent.
Pre-washing takes about 2 minutes and is immediately followed by the main
washing process.
Delicate fabric such as silk, wool do not need prewashing.
Divide colored and white clothing into seperate batches.
§ Depress one of the select switches
for SOFT or NORMAL washing.
§ Turn the washer timer to clockwise until you reach the desired wash time
position. This will activate the pulsator and washing will begin.
Do not attempt to turn the dial from “OFF” to the left, nor past the “15” mark.
3
After using the machine, unplug the
power cord from the socket.
Socket
Plug
Power cord
DRAIN
SOFT
BOTH-WAY
WASH AND
RINSE
WASH RINSE
SELECTOR
SWITCH
NORMAL
BOTH-WAY
Loading...