FEATURE CHART |
Here are the features of your new refrigerator. |
|
|
|
|
! |
@ |
# |
$ |
%
^
&
*
(
)
1
2
3 |
4 |
5
6
7
!ICE TRAY |
*REMOVABLE SHELF |
@FREEZER REMOVABLE |
(GLASS SHELF |
SHELF |
)VEGETABLE CASE |
#FREEZER TEMPERATURE |
1F POCKET (T) |
CONTROL |
2F POCKET (U) |
$ICE BOX |
3EGG CASE |
%CHILLED CASE |
4EGG POCKET |
^REFRIGERATOR |
5R POCKET (MULT) |
TEMPERATURE |
6R POCKET (BG) |
CONTROL |
7R POCKET (SM) |
&LAMP COVER |
|
and convenience it was designed to on page 1.
freezing. Place tray in freezer chest. To
. The shelf can be placed at your desirable
. Both the crisper and its cover shelf are to remove.
down.
function.
of ‘function
voltage, before inserting the power
to this unit with an attachment earthing
such as paining, near this unit.
as benzine, L.P. Gas, alcohol, etc., into
equipment near this unit. this unit by children.
supply cord within 5 minutes after release be occured to compressor.
1 |
2 |
HOW TO INSTALL
Location
Install refrigerator in a convenient location away from extreme heat and cold. Allow sufficient clearance between the refrigerator and side wall so it is easy for refrigerator to radiate heat. Refrigerator is not designed for recessed installation.
Leveling
Level refrigerator so it rests solidly on the floor, without rocking. There are two Adjustable foot, one at each front corner. Turn to the left to raise a corner, to the right to lower it. Use shims under rear corners, if necessary.
■If you want, the refrigerator door to close when not held open, adjust feets so that the front of the refrigerator is raised. However, front corners must be level with each other, and rear corners with each other.
NOTE: Make sure all packing meterial is removed. If the shipping tape has left a residue on the door, clean it with isopropyl alcohol (most rubbing alcohol is this type).
Do not use a solvent, such as cleaning fluid, nor an abrasive cleanser.
HOW TO CLEAN
To Avoid The Risk of Electrical Shock or Death unplug the CAUTION power cord before replacing a burned out light bulb or
cleaning.
Cleaners |
: Do not use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on |
|
any surface. These cleaners may cause cracking, discoloring or |
|
scratching the surface. |
Exterior |
: Wash with warm, soapy water, rinse and dry. |
|
Use appliance polish or wax periodically to keep the exterior looking like new. |
Door gasket |
: Clean at least twice a year with mild soap and water. Rinse and |
|
dry. Apply a light film of petroleum jelly to the gaskets to keep |
|
them soft. |
Interior |
: Wash the liner with warm, soapy water, rinse and dry. |
HOW TO OPERATE
CONTROL at the inside of the of cooling of each compartment.
Refrigerator temperature control
MED.
MIN.
MAX.
OFF
is already frozen enough, use this
.
“REFRIGERATOR CONTROL DIAL” at
Starting your new refrigerator
1.Clean the refrigerator thoroughly: Wipe the outside with a soft dry cloth, the inside with a damp cloth.
2.Set TEMPERATURE CONTROL at MED.
3.Connect the power supply cord.
To change temperature
You may want to adjust the control according to the season and your needs. When adjusting the temperature:
■Turn TEMPERATURE CONTROL toward MAX for colder temperature in refrigerator and freezer sections, and toward MIN for warmer temperature in refrigerator and freezer sections.
■Allow approximately 2 hours for temperature to stabilize. Then check to see if further adjustments are needed.
3 |
4 |