Daewoo AON-A72 User Manual

T ake a moment to know all the features and convenience it was designed to provide. Numbers match those in the illustration on page 1.
󱇲󱇲
Ice Tray
Fill tray 3/4
full to allow expansion of water during freezing. Place tray in
󱇲󱇲
Shelf
Both shelves can be removed by pulling forward. The shelf can be placed in either of two (higher or lower) positions.
󱇲󱇲
Vegetable Crisper
May be used for vegetable storage. Both the crisper and its cover are removable for easy cleaning. Simply slide forward to remove.
Here are the features of your new refrigerator .
CAUTION: 1. Confirm your voltage before inserting the power supply
cord into the socket.
2. Contact the earthing conductor to this unit with an attachment earthing screw.
3. Don’t make it spill to this unit.
4.
Don’t work with flammable spray , such as painting, near this unit.
5. Don’t put ignitable materials, such as either , benzine, L .P . Gas, alcohol, etc., into this unit.
6.
Precaution to the leakage of any gas equiment near this unit.
7.
Precaution not to hold on to the door of this unit by children.
8. Precaution not to reinsert the power supply cord within 5 minutes after release it from socket. If not, a trouble may be occured to compressor.
21
FEATURE CHAR T
! FREEZER SHELF @ ICE BOX # ICE TRAY $ TEMP CONTROL DIAL % LAMP SWITCH ^ SHELF & CRISPER COVER B
* VEGETABLECRISPER ( FREEZER POCKET ) EGG POCKET 1 BOTTLE POCKET(S) 2 BOTTLE POCKET(L) 3 ADJUST FOOT
T emperature is controlled automatically. The TEMPERA TURE CONTROL at the front side of the refrigerator section determines the amount of cooling your appliance receives.
4
HOW TO OPERATE
1. TEMPERA TURE CONTROL
3
NOTE :
Make sure all packing material is removed. If the shipping tape has left a residue on the door, touch the residue lightly with the adhesive side of tape of with isopropyl alcohol (most rubbing alcohol is this type).
Do not use a solvent, such as lighter or cleaning fluid, nor an abrasive cleanser.
HOW TO INSTALL
HOW TO CLEAN
Install refrigerator in a convenient location away from extreme heat and cold. Allow sufficient clearance between the refrigerator and side wall so the door will open for a fully usable interior. Refrigerator is not designed for recessed installation.
Level refrigerator so it rests solidly on the floor, without rocking. There are two leveling glides, one at each front corner. Turn to the left to raise a corner, to the right to lower it. Use shims under rear corners, if necessary .
󱇲 If you want, the refrigerator door to close when not held open, adjust glides
so that the front of the refrigerator is raised. However, front corners must be level with each other, and rear corners with each other.
󱇲 If you want the refrigerator door to remain motionless when open, adjust
the leveling glides so that all four corners are level with each other .
Cleaners: The cleaners noted below are available. Never use harsh,
abrasive cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, suday cloth, rinse and dry . For stubborn stains
and for periodic waxing, use sillicon wax.
Exterior: When refrigerator needs defrosting, set TEMPERA TURE
CONTROL at OFF Do not use sharp instruments.
Refrigeration Section:
Wash shelves, drawers and other removable parts in warm sudsy water, rinse and dry. Wash interior with baking soda solution (3 table spoons to one quart of water) or warm sudsy water .
Magnetic Door Seals: Wash with warm sudsy water. The finishing touch: Replace all parts, and return TEMPERA TURE
CONTROL to desired temperature.
Leveling
Location
Set TEMPERA TURE CONTROL at MED.
To start refrigerator
Disconnect the power supply cord. Remove ice tray and food. Leave doors ajar for air circulation and dehumidification of both sections.
To turn off refrigerator
Many factors influence the internal temperature of the refrigerator section and freezer section.
󱇲 The temperature and humidity of the home. 󱇲 The frequency of door openings and the amount of warm food placed in
the refrigerator.
󱇲 The combination of foods and containers stored in the refrigerator.
For these reasons, you may want to adjust the control to suit the season and your needs. When adjusting the temperature:
󱇲 Turn TEMPERA TURE CONTROL toward PULL DOWN for colder
temperature in refrigerator and freezer sections, and toward MIN for warmer temperature in both sections.
󱇲 Allow approximately 12 hours or overnight for temperature to stabilize.
Then check to see if further adjustments are necessary .
To change temperature
PULL DOWN
IN WINTER
MAX
OFF
MIN
MED
Loading...
+ 2 hidden pages