43
ECONOMIC FUNCTION
When you have small foods to stuff or the stuffed is already frozen enough, use this
function and you’ll save the electric power consumption.
OFF FUNCTION
When you want to use “FREEZER” only, set the “REFRIGERATOR CONTROL DIAL” at
“OFF”
T emperature is controlled automatically. The TEMPERATURE CONTROL at the inside of the
refrigerator and freezer section control the degree of cooling of each compartment.
Cleaners : Do not use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on
any surface. These cleaners may cause cracking, discoloring or
scratching the surface.
Exterior : Wash with warm, soapy water, rinse and dry.
Use appliance polish or wax periodically to keep the exterior looking like new.
Door gasket : Clean at least twice a year with mild soap and water. Rinse and
dry. Apply a light film of petroleum jelly to the gaskets to keep
them soft.
Interior : Wash the liner with warm, soapy water, rinse and dry.
CAUTION
Location
TEMPERATURE CONTROL
Leveling
To change temperature
Install refrigerator in a convenient location away from extreme heat and cold. Allow
sufficient clearance between the refrigerator and side wall so it is easy for refrigerator to
radiate heat. Refrigerator is not designed for recessed installation.
Level refrigerator so it rests solidly on the floor, without rocking. There are two
Adjustable foot, one at each front corner. Turn to the left to raise a corner, to the right to
lower it. Use shims under rear corners, if necessary.
If you want, the refrigerator door to close when not held open, adjust feets so that the
front of the refrigerator is raised. However, front corners must be level with each
other , and rear corners with each other.
NOTE:Make sure all packing meterial is removed. If the shipping tape has left a residue on
the door, clean it with isopropyl alcohol (most rubbing alcohol is this type).
Do not use a solvent, such as cleaning fluid, nor an abrasive cleanser.
1. Clean the refrigerator thoroughly: Wipe the outside with a soft dry cloth, the inside with
a damp cloth.
2. Set TEMPERATURE CONTROL at MED.
3. Connect the power supply cord.
Y ou may want to adjust the control according to the season and your needs. When
adjusting the temperature:
T urn TEMPERATURE CONTROL toward MAX for colder temperature in refrigerator and
freezer sections, and toward MIN for warmer temperature in refrigerator and freezer
sections.
Allow approximately 2 hours for temperature to stabilize. Then check to see if further
adjustments are needed.
To Avoid The Risk of Electrical Shock or Death unplug the
power cord before replacing a burned out light bulb or
cleaning.
Freezer temperature control
Refrigerator temperature control