Daewoo AD-13 User Manual
Drill 5/8" (15.875mm) dia. hole
D
Drill 5/8" (15.875mm) dia. hole
TOP CABINET TEMPLATE
E
filler block
INSTALLATION INSTRUCTION
STEP 1. Cut the edges of the template at A,B and C, to
top cabinet
template
BC
Smooth flat bottom cabinet Recessed bottom cabinet Filler block
top cabinet
template
center linecenter line
filler blocks
STEP 2. Drill 5/8" (15.875mm) diameter holes at
STEP 3. (Skip for horizontal exhaust installation)
fit in the recessed bottom of the top
cabinet so that template will lie flat
against the top cabinet.
D and E.
Cut out 2" (76.2mm) diameter hole
for power cord at F
Cut opening for vertical exhaust location.
filler block
use filler block when
cabinet bottom is
recessed
CAUTION
WARNING
Electric Shock Hazard
install power supply cord
bushing around hole drilled
in metal cabinet.
INSTALLATION OF THIS PRODUCT
REQUIRES TWO PERSONS.
STEP 4. Remove the top cabinet template.
STEP 5. Attach the filler blocks so that the holes
in each block line up with the corresponding
holes in the cabinet. The filler blocks should
be at the same levels as the bottom edge
of the top cabinet.
Failure to follow these instructions
could result in electrical
shock or other personal injury.
6.4 mm
1
0
/4’’
12.7 mm
1
0
/2’’
19.1 mm
3
0
/4’’
25.4 mm
1’’
31.8 mm
1
1
/4’’
WALL WALL
6.4 mm
1
0
/4’’
12.7 mm
1
0
/2’’
Cut out this area of upper cabinet bottom
if venting through the roof.
ROOF–VENTING INSTALLATIONS
OUTSIDE EXHAUST(VERTICAL)
CENTER LINE
31.8 mm
1
1
/4’’
19.1 mm
3
0
/4’’
25.4 mm
1’’
power supply cord hole
Cut out 2’’ dia. hole
F
For metal cabinet, put the tape
on edge of hole to protect
power cord from damage
CAUTION -IIF EXHAUST ADAPTOR IS POSITIONED OUTSIDE
RECOMMENDED DIMENSION, GREASE LADEN AIR WILL
DISCHARGE INTO HOUSE STRUCTURE.
6.4 mm
1
0
/4’’
12.7 mm
1
0
/2’’
19.1 mm
3
0
/4’’
25.4 mm
1’’
31.8 mm
1
1
/4’’
A
Loading...