Dae Myung Electronics HC108T Users Manual

1. User's manual

1. Outline

This digital wireless calling system consists of receiver and transmitter. Once

press the button of transmitter, signal is created by using radio wave

frequency of 433.92 . At the same time the receiver perceives registered㎒

received signal and announce it by calling sound(voice or melody).

2. Working method

1) RECEIVER

Connect the DC 12V power and turn on the ON/OF switch. Input the number

for calling using function button at the receiver

2) TRANSMITTER

Once user press the button of transmitter registered in the receiver then it

makes the signal with 433.92 and it is perceived by the receiver. At the㎒

same time number is displayed at the displaying part and beeper sound is

ringing at the speaker.

2. USER INFORMATION

Acknowledging Special Precautions and the FCC Industry Canada Notice

Cautions

Modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.

FCC compliance Information

When used the This device complies with part 15 of FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received.
Including interference that may cause undesired operation.

Information to User

This equipment has been tested and found to comply with the limits for a ClassBdigital
device, Pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio Frequency energy and,ifnot
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turningtheequipmentoffandon,theuser is
encouraged to try to correct the interference by one or more of the followingmeasures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

.