Page 1
VARIGRIP
PRODUCT MANUAL
HOW TO ADJUST PALMREST
+
1. Unlock both Palmrest Height
Locks (1) and lower or raise the
Palmrest (2) to your desired height.
HOW TO ADJUST TENSION
2. Unlock both Palmrest Height
Locks (1) and lower the Palmrest(2)
to expose the Tension Adjustment
Knobs (3). Turn the Knobs clockwise to
increase tension and countercloc kwise
to decrease tension. View your
current tension by viewing the Spring
Tension Indicator
1
2
1
3
2
1
1
Page 2
HOW TO CHANGE SPRINGS
1. Adjust the spring tension to
its lowest setting by unlocking
both Palmrest Height Locks (1)
and lowering Palmrest (2) to
expose the Tension Adjustment
Knobs (3). Turn the Knobs
counterclockwise, until the Spring
Tension Indicator (4) is lowered
all the way down.
2. Remove a silicone Finger Cap (1)
to expose the threaded Piston
Cov er (2).
3. Place the Spring Changing Tool (1)
over the exposed Piston Cover.
Turn counterclockwise to unscrew
the Piston Cover from the piston.
TIP: Keep Piston Cover inside the
Spring Changing Tool. Verify that
Spring Tension Indicator is at its
lowest setting.
1
2
4
3
2
1
1
1
Page 3
HOW TO CHANGE SPRINGS
4. Remove the Spring (1) from the
opened Piston (2) and replace it with
the new Spring. Green Springs lighter
tension. Red Springs for heavier
tension.
1
2
5. While holding the Piston (1) in
the upright position, screw in the
Piston Cover by turning the Spring
Changing Tool (2) clockwise until
you feel a click. Replace the Finger
Cap to complete the spring changing
process.
2
1
Loading...