Dacor MRE30S Installation Guide

Installation Instructions

Millennia ®Electric Range

For use with model MRES30

SAVE AND READ THESE INSTRUCTIONS

CONVENTIONS USED IN THESE INSTRUCTIONS

WARNINGS:

Must be followed carefully to avoid personal injury or damage.

NOTES:

Contain helpful hints and tips to facilitate the installation.

IMPORTANT

1. Before beginning installation, please thoroughly read and become familiar with these instructions.

2. Installation and service must be completed by a qualified installer or service agency.

3. Installer: Please leave these Installation Instructions with the owner.

4. Owner: Please keep these instructions for local electrical inspector's use and for future reference.

5. Read the accompanying use and care manual prior to operating this appliance.

TABLE OF CONTENTS

Important Safety Instructions .......................................................................................................................... Page 1

Electrical Power Supply Requirements .......................................................................................................... Page 2

Product Dimensions ......................................................................................................................................... Page 2

Planning the Location ...................................................................................................................................... Page 3

Cabinet and Countertop Preparation .............................................................................................................. Page 3-4

Verifying the Package Contents ...................................................................................................................... Page 5

Installing the Anti-tip Bracket .......................................................................................................................... Page 5

Removing the Oven Door ................................................................................................................................. Page 5

Removing the Kick Panel ................................................................................................................................. Page 5

Electrical Connection ........................................................................................................................................ Page 5-6

Installing the Range ........................................................................................................................................... Page 7

Re-installing the Oven Door .............................................................................................................................. Page 7

Verifying Proper Operation ................................................................................................................................ Page 7

I

I

Part No. 65166 Rev. K

IMPORTANT SAFETY INSTRUCTIONS

WARNINGS:

1. Read all instructions before
using the appliance.

. If the information in this

manual is not followed exactly,
a fire or explosion may result
causing property damage,
personal injury, or death.

.

Improper installation,
adjustment, alteration,

service or maintenance can

cause personal injury or
property damage. Refer to

these instructions and the

accompanying use and care
manual. For assistance or

additional information, consult
a qualified installer, service

agency or dealer.

.

For your safety:
Do not store or use gasoline
or other flammable vapors and
liquids in the vicinity of this or
any other appliance.

Do not obstruct the flow of

ventilation air to the unit.

Keep appliance area clear and

free from combustible material.

.

This appliance must not

be used in combination

with surface (countertop)
ventilation systems. The use

of an overhead hood, or Dacor
raised vent is recommended

for ventilation.

.

Use this appliance only for
its intended use as described

in this manual. Do not use
corrosive chemicals or vapors

in this appliance. This type of
appliance is not designed for
industrial or laboratory use.

10.

As with any appliance, close
supervision is necessary
when used by children.

11.

Do not operate this appliance
if it has a damaged electrical
cord, plug, conduit or wires,
if it is not working properly,
or if it has been damaged or
dropped.

12.

Installation of this appliance
must be performed by a
qualified installer or service

agency.

13.

This appliance should be
serviced only by qualified
service personnel. Contact the

nearest DACOR authorized
servicer at [phone],

or at www.Dacor.com for
examination, repair or

adjustment.

14.

Some products, such as whole
eggs, and sealed containers,
such as closed glass jars, may
explode and should not be
heated on this cooktop.

WARNING:

NEVER cover any slots, holes

or passages in the oven bottom
or cover an entire rack with

materials such as aluminum

foil. Doing so blocks air flow
through the oven and may

cause a fire hazard. Aluminum
foil linings may also trap heat,

causing a fire hazard.

WARNING:

NEVER use this appliance as a
space heater to heat or warm
the room. Doing so may result

in overheating of the appliance.

Range Data Plate Location

The range data plate specifies the model
number, serial number and electrical

supply requirements. It is located on the
left side wall inside the range storage
compartment.

<

6. Disconnect the electrical
supply before installing or

servicing the appliance.

.

This appliance must be

grounded. Connect only to a
properly grounded electrical

supply. Refer to "Electrical

Requirements."

8. Install or locate this appliance

only in accordance with these
installation instructions.

1 _acar

Electrical Power Supply
Requirements

Product Dimensions

It is the owner's responsibility to ensure

that the electrical connection of this

appliance is performed by a qualified

electrician. The electrical installation,

including minimum supply wire size and
grounding, must be in accordance with
the National Electric Code ANSI/NFPA

70-2002* (or latest revision) and local

codes and ordinances.

*A copy of this standard may be obtained
from:

National Fire Protection Association

1 Batterymarch Park

Quincy, Massachusetts 02269-9101

The correct voltage, frequency and

amperage must be supplied to the

appliance from a separate, grounded,

circuit that is protected by a properly sized

circuit breaker or time delay fuse.

Dedicated Total

Electrical Connected

Circuit Required Load

120/240Vac,

4-wire, 60Hz., 50Amp. 10.3kW (48.2Amp.)

Electrical Requirements

The above electrical specifications are for

reference only. See the range data plate
for exact specifications. See page 1 for

location.

[_ WARNING:

If the electric service provided

does not meet the product
specifications, do not proceed

with the installation. Call the
selling dealer or a licensed

electrician.

NOTE:

If the appliance is connected
to a 120/208 volt power supply,

preheat times and cavity
temperature recovery times will

be increased slightly.

Optional full
size side

5/16"- 1 13/16"

(8- 46mm)

Removable (factory

3" (76mm) side panels

60" (1524mm)long

240 Vac 4 wire

conduit location

!

35" '

(889mm)_

!

Dimensions - Isometric View

30"

(762mm)

Range top

Rear of control
Panel/oven door

Door opened

23 2"

(59 Im)

_.5._'16"
345rim',

/

Max. depth

to oven door
handle with
door closed

45 1/4"

(1149mm)

Dimensions - Top View

1

_acar 2

Planning the Location

NOTE:

The shaded areas shown in the
illustrations, denote the location

of the electrical junction box/
receptacle. This is the suggested
location. For replacement
purposes, the location of the
existing electrical supply may be
utilized provided that it does not

interfere with the sides or rear of
the range. Verify that the electrical

service meets local building
codes.

Access to the remote circuit breaker panel/
fuse box, with the range in place and

operating, must also be allowed for in
the installation• Any openings in the walt
behind the appliance and in the floor under
the appliance must be sealed•

36" (914mm) Recommended .___

30" (762mm) Min.

The electrical junction box/receptacle must
be located so that it does not interfere

with the range when it is installed and
under operation• In addition, the junction
box must be located so the range can

be removed for service when the conduit
supplied with the unit is attached to the

junction box. Do not lengthen the conduit
or wiring provided with the range•

All dimensions shown are based on
standard American cabinets 36 inches

(914mm) high at the finished countertop
by 24 inches (610mm) deep, with a 25

inch (635mm) overall countertop depth•

When installing the range into nonstandard
cabinets, minimum clearances shown in

the diagrams must be maintained•

Cabinet and Countertop Preparation

NOTES:

1.

If cabinet storage space is to
be provided directly above

the range, the risk of personal

injury may be reduced by
installing a ventilating hood

that projects horizontally a

minimum of 5 inches (127mm)
beyond the face of the

cabinets.

.

The range may be installed
flush to the rear wall. We

recommend installing a non-
combustible material on the

rear wall above the range
and up to the vent hood. It
is not necessary to install

non-combustible materials
behind the range below the

countertop height.

.

The minimum distance from
the sides of the range above

the countertop to combustible
side walls must be at least 10

inches (254mm).

Utilities may be located:

13"

(330mm

Max.

Hood

1. In the lower left corner of the adjacent
right cabinet• (Recommended)

2. Alternate location, in the lower right
corner behind the range•

Contact your local building department
to verify compliance with local code
interpretation•

10"(254mm) Min.

to combustible side

walls above therange
(both sides)

Freestanding Cabinet Dimensions and Clearances to Combustible Surfaces

3 _acar