If you have questions or problems with installation, contact your
Dacor dealer or the Dacor Customer Service Team. For repairs
to Dacor appliances under warranty call the Dacor Distinctive
Service line. Whenever you call, have the model and serial
number of the appliance ready. The model and serial number are
printed on the product data label.
Power cord not included. Not for
installation in Canada.
Cord connected, for installation in
Canada and U.S.A., where local
codes permit.
Power cord not included. Not for
installation in Canada.
Cord connected, for installation in
Canada and U.S.A., where local
codes permit.
Power cord not included. May be
installed in Canada and U.S.A.
Power cord not included. May be
installed in Canada and U.S.A.
Important Safety Instructions
Important Information About
Safety Instructions
The Important Safety Instructions and warnings in this manual
are not meant to cover all possible problems and conditions
that can occur. Use common sense and caution when installing,
maintaining or operating this or any other appliance.
Always contact the Dacor Customer Service Team about problems
and conditions that you do not understand.
DANGER
For your safety:
• Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
• Do not obstruct the flow of ventilation air to the unit.
• Keep appliance area clear and free from combustible
material.
WARNING
If the information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury
or death.
WARNING
NEVER use this appliance as a space heater to heat or warm
the room. Doing so may result in overheating of the appliance.
Safety Symbols in this Manual
DANGER
Immediate hazards that WILL result in severe personal injury or
death.
WARNING
Hazards or unsafe practices that COULD result in severe
personal injury or death.
CAUTION
Hazards or unsafe practices that COULD result in minor
personal injury or property damage.
WARNING
Tip-over hazard:
• A child or adult can tip the range and be killed.
• Attach the anti-tip bracket to the floor or wall as directed
in these installation instructions. Engage the floor or wall
mounted anti-tip bracket by sliding the rear leg on the range
into it according to these installation instructions. Using
a flashlight, be sure that the anti-tip bracket engages the
range’s rear leg as shown below.
•After moving the range, be sure to re-engage the rear leg into the anti-tip bracket as shown below.
• See the anti-tip bracket installation instructions in this guide
for further details.
• Failure to follow these instructions can result in death or
serious burns to children or adults.
WARNING
NEVER cover any slots, holes or passages in the oven bottom
or cover an entire rack with materials such as aluminum foil.
Doing so blocks air flow through the oven and may cause a fire
hazard. Aluminum foil linings may also trap heat, causing a fire
hazard.
READ AND SAVE THESE INSTRUCTIONS
Anti-tip
bracket
Rear leg
1
Important Safety Instructions
General Safety Precautions
To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety
precautions, including the following:
WARNING
• Read all instructions before using the appliance.
• Keep packaging materials away from children. Plastic
sheets and bags can cause suffocation.
• If you receive a damaged product, immediately contact
your dealer or builder. Do not install or use a damaged
appliance. Do not install or use the appliance if the conduit
is damaged.
• Improper installation, adjustment, alteration, service
or maintenance can cause personal injury or property
damage. Refer to these instructions and the accompanying
use and care manual. For assistance or additional
information, consult a qualified installer, service agency or
dealer.
• This appliance must be properly installed and grounded by
a qualified installer or service agency according to these
installation instructions prior to use. The installer must
show the customer the location of the circuit breaker panel
or fuse box so that they know where and how to turn off
electric power to the appliance. Dacor is not responsible for
service required to correct a faulty installation. The owner
is responsible to make sure this appliance is properly
installed.
• This appliance must not be used in combination with
surface (countertop) ventilation systems. The use of an
overhead hood, or Dacor raised vent is recommended for
ventilation.
• Disconnect the electrical supply before installing or
servicing the appliance.
• Install or locate this appliance only in accordance with
these installation instructions.
• This appliance must be grounded. Connect only to a
properly grounded electrical supply. Refer to Electrical
Requirements.
WARNING
• Before performing any type of service or installation, make
sure that the electric power to the appliance is turned off at
the circuit breaker or fuse box.
• Use this appliance only for its intended use as described
in this manual. Do not use corrosive chemicals or vapors
in this appliance. This type of appliance is not designed for
industrial or laboratory use.
• As with any appliance, close supervision is necessary when
used by children.
• Do not operate this appliance if it has a damaged electrical
wires, if it is not working properly or if it has been damaged
or dropped.
• This appliance should be serviced only by qualified service
personnel. Contact the nearest DACOR authorized servicer
at (800) 793-0093, or at www. dacor.com for examination,
repair or adjustment.
• Some products, such as whole eggs, and sealed containers, such as closed glass jars, may explode and should not be
heated on this cooktop.
2
Product Specifications
WARNING
IMPORTANT: Observe all governing codes and ordinances
during planning and installation. Contact your local building
department for further information.
Electrical Requirements (All models
except those ending with -C)
It is the owner’s responsibility to ensure that a licensed electrician
performs the installation of the electrical supply for this appliance.
The electrical installation, including minimum supply wire size,
must comply with the National Electric Code ANSI/NFPA 70 (latest
revision) and local codes and ordinances. A copy of this standard
may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, Massachusetts 02269-9101
The correct voltage, frequency and amperage must be supplied
to the appliance from a dedicated, grounded, single phase circuit
that is protected by a properly sized circuit breaker or time-delay
fuse. If a time-delay fuse is utilized, fuse both sides of the line (L1
and L2).
* Two 120 Vac hot (L1 and L2), one neutral (N1) and one ground.
The above electrical specifications are for reference only. See
the range data label for exact specifications. See inside cover for
location.
•The wiring needs to be long enough to allow the range to be
pulled out for service, while remainingconnected.
•The wiring connected to the range must:
◊Meet NEMA standards and have a minimum rating of
250 Volts @ 50 Amp.
◊Include a strain relief
◊Be terminated by tinned leads, closed loop terminals or
open ended spade lugs with upturned ends
◊Connect to a junction box or receptacle installed by a
licensed electrician
The appliance may be connected one of the following ways:
•Using conduit:
◊A 4-wire conduit connected to a 4-wire junction box, or
◊A 3-wire conduit (where local code permits) connected to
a 3-wire junction box.
Suggested conduit wiring color code: black, white, red
and green.
•Using an appliance cord:
◊A 4-wire appliance cord equipped with a NEMA 14-50P
plug connected to a NEMA 14-50R receptacle, or
◊A 3-wire appliance cord (where local code permits)
equipped with a NEMA 10-50P plug connected to a
NEMA 10-50R receptacle
Appliance cord plug must be UL listed type SRD or SRDT.
Electrical Requirements (Models
DR30ES-C and DR30EFS-C)
•Models DR30ES-C and DR30EFS-C are freestanding ranges
that come with a factory installed 4-wire appliance cord and
NEMA 14-50P plug. This wiring configuration is required
for freestanding ranges installed in Canada, although they
may be used elsewhere, if local codes permit. The plug
is designed to plug directly into a NEMA 14-50R electrical
receptacle installed by a licensed electrician according to
the specifications below. Do not modify the factory wiring on
models with -C at the end of the model number.
•It is the owner’s responsibility to ensure that the required
4-wire electrical outlet compatible with the power cord is
installed by a licensed electrician as specified below prior to
range installation. The electrical outlet installation, including
minimum supply wire size and grounding, must be in
accordance with all governing codes and ordinances.
•The correct voltage, frequency and amperage must be
suppliedto the appliance from a separate, grounded, circuit
that is protected by a properly sized circuit breaker or time
delay fuse. If a fuse is utilized, fuse both sides of the line (L1
and L2). Refer to the ratings on the range rating label.
**Models DR30EIS and DR30EIFS come equipped from the factory with a flat
stainless trim piece in place of a backguard. A backguard may be purchased as
an optional accessory. Add an additional 1/16 inch to depth dimensions above
when installing a backguard on models DR30EIS and DR30EIFS.
The trim on models DR30ES and DR30EFS are not compatible with a raised vent.
Models DR30EIS and DR30EIFS are compatible with Dacor raised vent models
ERV30 and ERV3015. Use only theses specified raised vent models.
Standard on models DR30ES, DR30EFS
Optional on models DR30EIS, DR30EIFS
DR30EFS
DR30EIFS
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.