For DACOR
Built-in Kit Models
AO MT K2 7
or
A OM TK 30
THIS KIT IS UL APPROVED TO ALLOW CERTAIN MICROWAVE OVENS TO BE INSTALLED ABOVE CERTAIN CONVENTIONAL/CONVECTION WALL
AS AN APPROVED MAKE AND MODEL, THEN DO NOT INSTALL THE MICROWAVE OVEN IN ANY AREA WHERE HEAT AND STEAM ARE GENERATED;
I N S T A L L A T I O N I N S T R U C T I O N S
EO127, EO130, MOV127, MOH127, MOV130, MOH130, PO127, PO130
This Built-in Kit is designed for and approved only for those DACOR Microwave Ovens specifying Built-In Kit AOMTK27
or AOMTK30 on the rating label on the left side wall of the oven cavity.
The cabinet or wall opening must be within the following dimensions:
HEIGHT : 16
3
/
4
3
/8/
DEPTH : minimum 20"
Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the Built-in Kit.
Because the kit includes metal parts, due caution should be used in handling and installation to avoid the possibility of
IMPORTANT :
1
3
2
4
opening correctly, its fl anges will be tightly against the
2. Secure the EXHAUST DUCT ASSEMBLY with two
A
The opening in the wall or cabinet must be within the
following dimensions:
A HEIGHT : 16
3
/
4
3
/8/
Outlet should NOT be in the shaded area as indicated on
If the dimension of DEPTH (C) is more than 21", the
outlet location may be any area on the rear wall.
The fl oor of the opening should be constructed of
oven and fl oor load (about 100 pounds). The fl oor
should be level for proper operation of the oven.
ceiling and rear partition. The proper functioning
of the oven does not require the enclosure.
STEP 1 C A B I N E T O R WA L L O P E N I N G
Figure 1
STEP 2 E X H A U S T D U CT A S S E M B LY I NS TALLAT I O N
Figure 2
3
STEP 3 O V E N I N S TALL ATION
outlet.
2. Carefully guide the assembled oven into the prepared
opening. Slide the oven on the EXHAUST DUCT
ASSEMBLY. See Figure 3. Avoid pinching the cord
of the oven so that the feet of the oven are fi tted into
the recesses of the EXHAUST DUCT ASSEMBLY. See
to be square with the
oven. Carefully place the FRAME ASSEMBLY on the
oven. Check that it is level and then secure with two
2. Secure the bottom portion of the
with the two remaining SCREWS B. See Figure 5.
Figure 3
Figure 4
STEP 4 F R A M E I N S TAL L ATION
Figure 5
4
TINSEB422MRR0
OVER OVEN INSTALLAT I O N
1
1
/
4
WARMING OVEN
1
3
/
/
4
TOP OF
41"
AND MILLENNIA
36"
OVER WARMING O V E N I N S TALLATION
Loading...