Dacor AGDRT12 Use & Care

Cooktop/Range Models: DRT366S, ER36G and ER36GI

Grill Placement and Use

INSTRUCTIONS

Grill Models: AGDRT12 and AGRG12

WARNING: Do not touch the grill when hot.

WARNING: Do not use water on grease res. A violent steam explosion may result. Smother any

ames with a lid, cookie sheet or at tray. Use baking soda or a foam extinguisher to extinguish am­ing grease. Be careful to avoid getting burned.

WARNING: This grill has a non-stick coating. Non-stick coatings, when heated, can be harmful to
birds. Remove birds to a separate, well-ventilated room during cooking.

CAUTION: This grill kit comes with two extra knobs marked with the words MAX GRIDDLE. They
must be installed according to these instructions before use to prevent damage to the grill.

CAUTION: Place the grill only in the position shown in these instructions. Do not turn the burners un­der the grill higher than the MAX GRIDDLE setting. Setting the burner ames too high or putting the
grill in the wrong position may damage it permanently.

Initial Set Up

Before using the griddle for the first time...

STEP 1 Decide which side of the cooktop/range you want to use the griddle on. Remove the two knobs on the far

right or the far left of the control panel based on the side the griddle will be used. Leave all other knobs in
place.

NOTE: If you have difculty removing any of the knobs, a rubber grip (strip) is included with the kit. To use,

peel the protective backing off of the rubber strip and wrap the adhesive side around the knob as shown.
The grip can be peeled off and reapplied to the other knobs.

Knob Grip Installation

continued...

Part No. 106558 Rev. D

Grill Placement and Use

Initial Set Up (continued)

STEP 2 Put the new knobs from the kit, with the words MAX GRIDDLE on them, on the valve shafts in place of

the knobs removed in step 1. The knob with the shortest space between the ame icon and the simmer
icon goes on the valve stem for the standard burner A . The other knob installs on the valve stem for the
SimmerSear (dual) burner B . When installing the knobs, align the “D-shaped” opening on the back of
the knob with the end of the valve shaft. Carefully push the knob on until it stops. The old knobs may be
discarded.

A New standard burner knob with short space between icons

B New SimmerSear (dual) burner knob with wide space

between icons

A

A

B

or

B

A

STEP 3 Wash the griddle in hot soapy water. Rinse it and allow it to dry thoroughly.

B

or

B

A

ER36G and ER36GI RangeDRT366S Cooktop

Page 2