Cooktop and Range Models:
ER30D, ER30G, EG366, ER36D, EG486 and ER48D
Griddle Placement and Use
INSTRUCTIONS
Griddle Models: AG1424 and AGDG14
WARNING: Do not touch the griddle when hot.
WARNING: Do not use water on grease res. A violent steam explosion may result. Smother any
ames with a lid, cookie sheet or at tray. Use baking soda or a foam extinguisher to extinguish aming grease. Be careful to avoid getting burned.
WARNING: Non-stick coatings, when heated, can be harmful to birds. Remove birds to a separate,
well-ventilated room during cooking.
CAUTION: Place the grill only in the position shown below. Do not turn the burners under the grill
higher than the “MAX GRIDDLE” setting. Setting the burner ames too high or putting the grill in the
wrong position may damage it permanently.
Part No. 101508 Rev. D
Griddle Placement and Use
Instructions
STEP 1: Before using the griddle for the rst time, wash it in hot soapy water. Rinse it and allow it to dry
thoroughly.
STEP 2: Make sure all burners are off and the cooktop or range is cool to the touch. Put the griddle over the
top of the grates on the cooktop or range in the position shown. The grease trap goes toward the
back. Fit the tabs that stick out of the bottom of the feet into the inside corners of the grate. When
correctly installed, the griddle will rest securely about 1/2” above the top surface of the grate. It may
rock back and forth slightly, which is normal.
STEP 3: Set one of the burners under the griddle to the light (high) position. Once lit, turn the knob to the
MAX GRIDDLE position, or lower if desired. DO NOT keep the burner knobs higher than the MAX
GRIDDLE setting after they are lit!
STEP 4: Repeat Step 3 for the other burner under the griddle.
STEP 5: During cooking be careful with metal utensils on the surface because they can scratch the non-
stick coating. See back for cleaning instructions.
Cleaning the Griddle
After each use, wash the griddle thoroughly in hot soapy water to avoid stains from grease
build-up. The griddle is coated with a non-stick coating for easy cleaning. Warm water and liquid
detergent are all that are needed for cleaning. Remove stubborn spots with a non-abrasive
plastic mesh pad. To prevent scratching, do not use abrasives or abrasive cleaners.
Grease trap
toward back
Line up bottom of
griddle with top of grate
EG366 and EG486
Put over center burners
Page 2