Dacor AERB30G03, AERB30G09, AERB30G06 User Manual

RANGE MODEL: ER30G

DANGER:

Instructions:

Backguard Kits

AERB30G03, AERB30G06, AERB30G09

INSTALLATION

INSTRUCTIONS

Electric shock and explosion hazard! Before installation,
disconnect the power cord and shut off the gas supply
valve.

Backguard height varies with kit

STEP 1: Disconnect the power cord to the range. Turn off the gas at the gas supply

valve.

STEP 2: Slide the range out from the cabinet.

STEP 3: Remove the grates.

WARNING: Do not disassemble the range until it has cooled.

STEP 4: Remove and retain the three (3) screws on the front of the existing backguard.

STEP 5: Remove the two (2) top screws on the back of the side panels.

STEP 6: Remove the existing backguard.

Continued on back...

Backguard Removal

Part No. 106191 Rev. B

STEP 7: Remove the protective plastic cover

from the new backguard.

STEP 8: Place the new backguard over the back

of the range. The backguard ts over

the exhaust duct sticking up on the

back of the unit. Be sure to slide the
tabs on the back of the backguard in­side the anges on the back of the unit.

STEP 9: Fasten the backguard in place with the

three (3) existing chrome plated screws.

Backguard

Chrome Plated
Screw, 3 Places

STEP 10: Tighten the two (2) top screws on the

back of the side panels.

STEP 11: Reinstall the grates.

STEP 12: Turn on the gas at the gas supply valve.

Connect the power cord to the electrical outlet.

Screw,
2 Places

Exhaust

Duct

Tab

Flange

Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: [phone] ● FAX: [phone] ● www.Dacor.com