CYUSBS232 QUICK START GUIDE
Step 2: Powering the board*
• Connect the board to the PC using the USB cable
• LED D1 (as shown in next page) glows to
indicate the board is powered
Step 1: Software Installation
• Download and Unzip the ISO le from
www.cypress.com/go/CYUSBS232
• Run cyautorun.exe and follow the steps in the
installer window
• Install Tera Term from the following location:
<install directory>/Cypress/CYUSBS232 RDK/
1.0/teraterm
Step 3: Enumeration
• Device will appear as a USB Serial Port (COM#)
in the Device Manager (For example, in Win 7,
click Start > Control Panel > Device Manager)
Step 4: Testing basic UART functionality
• Connect TXD to RXD with the “Jumper wire”,
refer picture in next page
• Run Tera Term (Start > All Programs > Tera Term)
• In ”Tera Term: New Connection“ window, click
Serial and select Port (COM#), click OK
• Enable local echo option (go to Setup > Terminal
and check the local echo box)
• Type “HELLO WORLD”. Text will appear
on the same terminal **
2
* Connect the board to PC only after software installation. For the latest software updates and MAC/
LINUX/Android users visit www.cypress.com/go/usbserial
** Each character will appear twice – “HHEELLLLOO WWOORRLLDD”
Notes:
Kit operation: Data is transmitted from USB to UART (TXD). The TXD-RXD loop back connection enables the data
to be fed back to the UART (RXD) to USB and is displayed on the Tera Term window
3
4
1
Kit Based on USB-UART LP Bridge – CY7C65213
USB-UART REFERENCE DESIGN KIT
© 2013 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the properties of their respective owners.
Doc.# 001-87063 Rev.*C
CYUSBS232 QUICK START GUIDE
USB-UART REFERENCE DESIGN KIT
Micro-B
Connector
USB-UART LP
CY7C65213
D2 - Tx Activity LED
D3 - Rx Activity LED
GPIO0
CTS#
DCD#
DSR#
RI#
RXD
RTS#
GND
TXD
DTR#
GND
VBUS
VCCIO_OUT
GPIO2
GPIO4
GPIO3
GPIO1
GPIO0
GND
GND
VBUS
VCCIO_OUT
GPIO2
GPIO4
GPIO3
GPIO1
Top View Bottom View
Not Used
D1 - Power LED
For the latest information about this Kit and to download Kit Software and Hardware les,
visit www.cypress.com/go/CYUSBS232
Step 5: 10 MB File transfer at 3 Mbps, with no Data-Loss
• In the Tera Term window, go to Setup > Serial Port, enter 3000000 in baud rate box, and select
Hardware in Flow control drop-down menu; go to Setup > Terminal > Receive, select CR+LF
• Connect TXD to RXD and CTS# to RTS#, with “Jumper Wires”
• Enable le capture: go to File > Log; uncheck Append and select <le name> to save the received data
• Go to File > Send File, select Test.txt le from <Install directory>\Cypress\CYUSBS232 RDK\1.0
• “Tera Term: Send le” window shows effective data throughput; multiply by 2X to get uni-directional
throughput. Actual throughput will be less than 3 Mbps, usually around 1 Mbps, due to protocol overhead
and PC Application latency
• Compare Test.txt and Received le, using le compare utilities to verify data integrity
Loading...