Cypress CYW920819EVB-02 Quick Start Manual
CYW920819EVB-02 EVALUATION KIT QUICK START GUIDE
CYW920819EVB-02 EVALUATION KIT
Kit Contents:
1 CYW920819EVB-02 evaluation board
2 USB standard-A to micro-B cable
3 Quick start guide (this document)
www.cypress.com/CYW920819EVB-02
1 2
1. Register on Cypress WICED Community and
then download and install ModusToolbox
1.1 (or later) at
www.cypress.com/modustoolbox
2. To learn more about this kit, refer to the
kit user guide at
www.cypress.com/CYW920819EVB-02
1. Plug the kit into a USB port on your
computer.
2. Open a Terminal Emulator such as Tera
Term and make settings as shown above.
(The port may be different for your
computer. Use the WICED Peripheral UART
port number from the device manager.)
The terminal window will display the
thermistor resistance and the equivalent
temperature.
(Note: The temperature is transmitted over
Bluetooth LE every 5 seconds so you can
also use any mobile app that supports the
Environment Sensing prole to test this
example project.)
CYW920819EVB-02 EVALUATION KIT QUICK START GUIDE
CYW920819EVB-02 EVALUATION KIT
CYW920819EVB-02 Evaluation Board Details
32 31 30
29 28
1
2
3
4
5
6
7
8
9
10
1. HCI UART Jumper (J5)
2. Motion Sensor (U2)
3. VDDIO Select Jumper (J7)
4. USB Connector for Programming
/USB-UART (J6)
5. VBATT Select Jumper (J8)
6. VPA_BT Select Jumper (J16)
7. PUART Enable Jumper (J10)
8. SWD/GPIO Switch (SW9)
9. Debug Header (J13)
10. Thermistor (R30)
11. Thermistor Enable Jumper (J14)
12. Peripheral Enable Jumper (J18)
13. External LPO Enable Jumper (J19)
14. VDDIO Current Measurement
Jumper (J15)
15. Recovery Button (SW1)
11
14 16 17 18
12 13 15
17. Reset Button (SW2)
18. Arduino Header (J12)
19. User Button (SW3)
20. User LEDs (D1 and D2)
21. LED Enable Switch (SW4)
22. External Antenna Connector (U1.J3)
23. PCB Antenna (U1.A1)
24. CYW20819 (U1.U1)
25. Carrier Module (U1)
26. Coin Cell Holder (ZB1, bottom side)
27. 8-Mb SPI Flash (U6)
28. Arduino Header (J4)
29. WICED Header (J2)
30. Arduino Header (J3)
31. WICED Header (J1)
32. Motion Sensor Interrupt Test Points (J17)
16. Arduino Header (J11)
For the latest information about this kit, visit www.cypress.com/CYW920819EVB-02
27
26
25
24
23
22
21
20
19
© 2019 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the property of their respective owners.
002-25813 Rev.**
Loading...