Cypress CHDMI-210T Operation Manual

2x10 HDMI

Splitter

Operation Manual

CHDMI-210T

1. Introduction

Cypress CHDMI-210T is a high performance 2 input-10 output HDMI splitter

with separate optical audio and remote control. It allows you to connect up to
2 HDMI source and 10 HDMI displays. The 10 HDMI outputs are identical.

2. Features

1. Two HDMI sources to connect up to 10 HDMI displays simultaneously

2. HDCP keysets allows each output to work independently when connecting
to a HDMI display.

3. Splits a HDMI source up to 10 outputs without signal loss.

4. Supports DVI source and DVI display by using HDMI to/from DVI adaptor cable.

5. Supports a wide range of PC and HDTV resolutions from VGA to UXGA
and 480p to 1080p. Maximum resolution bandwidth 165MHz.

6. Can be cascaded for more outputs

7. Each of the buffered output can run up to 20 Meters @1600x1200.

8. Support multi channel audio.

9. Full HDCP Compliant.

10. Separate toslink output.

3. Operation Controls and Functions

Front Panel

1 2 3

4 5 6

7 8

1. Remote Control Sensor.

2. AUDIO IN Select/Indicator:
Press the "AUDIO IN" button sequentially to switch to your desired input
audio source (HDMI, OPTICAL 1 and OPTICAL 2), the LED will illuminate to
indicate which input source is selected.

3. HDMI IN Select/Indicator:
Press the "HDMI IN" button sequentially to switch to your desired input
audio/video source (HDMI 1 and HDMI 2), the LED will illuminate to indicate
which input source is selected.

4. HDCP Indicator:
The LED will illuminate when the selected HDMI input source is HDCP-protected.

5. HDMI/DVI Indicator: The LED will illuminate when the selected HDMI input
source is originally from an HDMI output, the LED will not illuminate when the
selected HDMI input source is originally from a DVI output.

6. SYNC Indicator:
The LED will illuminate when the selected HDMI IN connects to an HDMI
or DVI output correctly.

7. Key Lock:
Press and hold the "POWER" button for 5 seconds will enter the Key Lock mode,
Key Lock LED will illuminate and all buttons will not function.
Press and hold the "POWER" button for 5 seconds again to disable the Key Lock mode.

8. POWER Switch/Indicator:
Press the "POWER" button to turn on/off the power, the LED will illuminate when
the power is turned on.

CHDMI-210T 2x10 HDMI SPLITTER

HDMI

INT

HDCP KEY LOCKHDMI/DVI

AUDIO IN HDMI IN POWER

HDMI 1 HDMI 2 SYNC1 2

OPTICAL