CYP AU-11SA Operation Manual
AU-11SA
V1.3 HDMI to HDMI Repeater
with Audio Decoder
OPERATION MANUAL
1. Introduction 1
2. Features 1
3. Package Contents 1
4. Operation Controls and Functions 2
4.1 Front Panel Diagram 2
4.2 Rear Panel Diagram 3
5. Connection Diagram 4
6. Specications 4
Table of Contents
Finden Sie ab Seite 7.
1. Introduction
The AU-11SA is an advanced solution for HDMI to HDMI repeating with Audio
decoding. It is compatible with v1.3 HDMI specications, a cutting-edge technology
which denes the transfer of Deep Colour (12 bits/colour) video with a high
bandwidth up to 225MHz. The AU-11SA also boasts signal amplication and
equalization of the signal at the output. The audio output supports uncompressed
analogue LPCM 7.1 and new lossless compressed digital Bitstream (Dolby TrueHD,
Dolby Digital Plus and DTS-HD Master Audio)
2. Features
• Compliant with v1.3 HDMI, HDCP 1.1 and DVI 1.1 standards.
• Supports digital video formats in ‘Deep Colour’ mode from 25MHz to 225MHz
for 10/12bits colour.
• Supports high denition input up to 1080p@(24/50/60)Hz, output resolution
follows input.
• Supports HDMI signal amplication and equalisation at the HDMI output.
• Supports uncompressed digital LPCM 7.1, 5.1 or 2 channels and compressed
digital Bitstream (Dolby TrueHD, Dolby Digital Plus and DTS-HD Master Audio)
through HDMI input and output ports.
• Supports digital Dolby 5.1/2 and LPCM 2 channels output through optical
output.
• Supports LPCM 7.1, 5.1 or 2 channels output through multichannel analogue
output ports.
• Integrated HDCP encryption for transmitting protected audio and video content.
• Support CEC bypass.
3. Package Contents
• AU-11SA
• 5V DC power supply adaptor.
• Operation Manual.
Page 1
Page 2
4. Operation Controls and Functions
4.1 Front Panel
1. HDMI input: Connect the HDMI input port to the HDMI output port of your
source equipment such as DVD player or set-top-box.
2. Audio selection switch: To switch between Bitstream/LPCM7.1/5.1/LPCM2
channels.
Note: When switching to other audio mode it is normal for the display
to
disappear
for a few seconds.
3. Power: Plug the 5VDC power supply into the unit and connect the
adaptor to
AC wall outlet.
LPCM
5.1/7.1CH
2CH
BITSTREAM
DC 5V
HDMI INPUT
POWER
1 32
Page 3
4.2 Rear Panel
1. HDMI output: Connect the HDMI output port to the HDMI input port of your
display.
NOTE THE HDMI OUTPUT MUST BE CONNECTED.
2. Multi channel output: Connect the audio channel output to the input of your
amplier equipment and follow the ampliers connection instructions.
• FL: Front Left
• FR: Front Right
• LFE: Low Frequency Effect
• FC: Front Centre
• RL: Rear Left
• RR: Rear Right
• RLC: Rear Left Centre
• RRC: Rear Right Centre
3. Optical output: Connect Optical output to the display audio input or audio
equipment for Dolby5.1/2 and LPCM2 channels.
1
OPTICAL OUTMULTI CHANNEL OUTHDMI OUT
FL/FR LFE/FC RL/RR RLC/RRC
2 3
Loading...