CYLINDA IH 710 User Manual
instructions for use
IH 715 RF
IH 710
120/160/210 mm 145 mm
180 mm145 mm
TABLE OF CONTENTS
IMPORTANT SAFETY INSTRUCTIONS .........................................................................3
SAFEGUARDING THE ENVIRONMENT ........................................................................4
DECLARATION OF CONFORMITY................................................................................4
INSTALLATION .............................................................................................................4
ELECTRICAL CONNECTION..........................................................................................6
CONTROL PANEL DESCRIPTION .................................................................................7
POWER LEVEL TABLE................................................................................................... 9
CLEANING.....................................................................................................................9
TROUBLESHOOTING GUIDE......................................................................................10
AFTER-SALES SERVICE ..............................................................................................10
1
IMPORTANT SAFETY INSTRUCTIONS
YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT
This manual and the appliance itself provide important safety messages, to be read and always observed.
This is the danger symbol, regarding safety, warning of potential risks to users and others.
All safety messages will be preceded by the danger symbol and the following words:
DANGER
WARNING
Indicates a hazardous situation which, if not avoided, will result in serious injury.
Indicates a hazardous situation which, if not avoided, could cause serious injury.
All messages relevant to safety specify the potential risk to which they refer and indicate how to reduce the risk of injury,
damage and electric shocks due to incorrect use of the appliance. Make sure to comply with the following:
- Use protective gloves to perform all unpacking and installation operations.
- The appliance must be disconnected from the power supply before carrying out any installation operation.
- Installation and maintenance must be carried out by a specialised technician, in compliance with the manufacturer’s
instructions and the local safety regulations in force. Do not repair or replace any part of the appliance unless
specifically stated in the user manual.
- The appliance must be earthed.
- The power cable must be long enough for connecting the appliance, fitted in the cabinet, to the power supply.
- For installation to comply with the current safety regulations, an omnipolar switch with minimum contact gap of 3mm
is required.
- Do not use multi-sockets or extension cords.
- Do not pull the appliance’s power cable.
- The electrical parts must not be accessible to the user after installation.
- The appliance is designed solely for domestic use for cooking food. No other use is permitted (e.g. heating rooms). The
Manufacturer declines any liability for inappropriate use or incorrect setting of the controls.
- The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating
elements. Very young (0-3 years) and young children (3-8 years) shall be kept away unless continuously supervised.
- Children from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge can use this appliance only if they are supervised or have been given instructions on safe
appliance use and if they understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.
- Do not touch the appliance heating elements during and after use. Do not allow the appliance to come into contact
with cloths or other flammable materials until all the components have cooled down completely.
- Do not place flammable materials on or near the appliance.
- Overheated oils and fats catch fire easily. Pay attention when cooking food products rich in fat and oil.
- A separator panel (not supplied) must be installed in the compartment under the appliance.
- If the surface is cracked, switch off the appliance to avoid the possibility of electric shock (only for appliances with glass
surface).
- The appliance is not intended to be operated by means of an external timer or separate remote control system.
- Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. NEVER try to extinguish a fire with
water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket.
Danger of fire: do not store items on the cooking surfaces.
- Do not use steam cleaners.
- Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot.
- After use, switch off the hob element by its control and do not rely on the pan detector (only for induction appliances).
EN4
SAFEGUARDING THE ENVIRONMENT
After unpacking the product, check for
any damage during transport. In case
of problems, contact the dealer or the
After-Sales Service.
For buit-in dimensions and installation
instruction see the pictures in this
paragraph.
A minimum distance must be
maintained between the hob and the
hood above it. Please refer to the user
manual of the hood for more
informations.
R = Min. 6,5 mm
Max. 8 mm
490 mm
560 mm
0
+2
0
+2
Min. 70 mm
6 mm
min 20 mm
513 mm
583 mm
0
+2
0
+2
560 mm
490 mm
R = 11,5 mm
0
+2
0
+2
R = Min. 6,5 mm
FLUSH INSTALLATION
482 mm
552 mm
42/46 mm
510 mm
580 mm
Min. 70 mm
STANDARD INSTALLATION
580 X 510 mm
Disposal of packing
The packing material is 100% recyclable and marked with the recycling symbol ( ). The various parts of the packing must not be dispersed in the environment, but
disposed of in compliance with local regulations.
Disposal
This appliance is marked in conformity with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring that this appliance is correctly disposed of, the user can help prevent potentially negative consequences for the environment and the health of people.
The symbol on the appliance or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to an
appropriate collection point for recycling WEEE.
DECLARATION OF CONFORMITY
- This appliance, intended to come into contact with food products, complies with Regulation ( ) no. 1935/2004, and has been designed, manufactured and
marketed in conformity with the safety requirements of “Low Voltage” Directive 2006/95/EC (replacing 73/23/EEC as amended) and protection requirements of
“EMC” Directive 2004/108/EC.
INSTALLATION
Min. 40 cm
Min. 10 cm
EN5
Loading...