Cygnett CYG User Manual

GoStick

BLUETOOTH

FOLD

GoPro Mount

Mount your GoPro in the
mount provided, but replace
the tightening screw at the
base of the phone mount with
the extra-long adjusting screw.

SELFIE-STICK

Pairing your shutter button with your Apple or Android
device is easy.

FOR SMARTPHONE S AND GoPro® MOUNT
COMPATIBLE CAM ERA S

Phone mount

Place your smart phone or camera in the clip by lifting
the tab at the top and gently placing it on your phone
until it is tight and secure. Pull the spring mounted

FOLD FOLD

phone holder and release with phone in place to hold
your phone tightly.

Email: [e-mail]
Phone: [phone]
Address: Level 1, 664 Lorimer Street
Port Melbourne, Victoria, Australia 3207

Twist and lock
extendable pole.

Twist left and pull apart
to extend, and then twist
right to lock in place.
Reverse to close and lock.

Mini tripod

Extend 3 legs and place on flat ground for
hands-free selfies or video.

CAUTION: Do not use on uneven ground.
Do not use in windy conditions. Any damage done to the digital device or
accessory as a result of the tripod falling over will not be covered by Cygnett.

1. Switch button on the side of the remote to ‘ON’, and a light will flash
blue. Then go to your smartphone’s Bluetooth settings, ensure Blutooth is
turned on, and select for ‘AB Shutter 3’ when it appears.

a. iOS/Apple: Settings > Bluetooth > Turn Bluetooth on. It will autmatically start
searching for devices.
b. Android: Menu > Settings > Wireless & Network > Bluetooth settings > turn
Bluetooth on by checking box. Then select ‘Search for Devices’.

2. You’re now ready to use the Selfie Stick. Use the corresponding
shutter button on the remote to activate the shutter button.

Compatible with Android 4.2.2 OS or newer and iOS 6.0 or newer.
In the event of an incompatibe version of Android OS, Cygnett recommends the
Camera 360 Ultimate* app, available on Android and iOS platforms.

changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation.

If this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment
and receiver.

- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV
technician for help.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.

*TheCamera 360 Ultimate app is the property of PinGuo Inc. and/or its affiliates.

CMYK PROCESS PANTONE

021C

FOLD