Cyber Power Systems P600WUCHD User Manual

YOUR ULTIMATE ALLY IN POWER
6-OUTLET
SURGE PROTECTOR WALL TAP
(6 AC OUTLETS & 2 USB PORTS)
P600WUCHD
USER MANUAL
4
FEATURES
1. Standard Grounded Outlets (6)
2. USB-A Charging Port (1)
3. USB-C Charging Port (1)
4. Anchoring Screw
SPECIFICATIONS
Model Number: P600WUCHD Outlets: Standard Grounded Outlets (6),
USB Charging Ports (2) Surge Protection: 500 Joules USB-A Charging Output: 5 V/2.4 A USB-C Charging Output: 12 W USB Output Total: 12 W Electrical Rating: 125 V/15 A/1875 W UL Clamping Voltage: UL 1449 4th/800 V (H-N) Maximum Peak Current: 15,000 A EMI/RFI Filtration: 150 kHz to 100 MHz
i WARNING: This product can expose you to chemicals including bisphenol A (BPA) and styrene, which is known to the State of California to cause reproductive harm and cancer. For more information, go to www.P65Warnings.ca.gov.
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK:
Use only in dry locations and only indoors.
Use only with duplex receptacle having center screw.
DO NOT plug into another relocatable power tap.
1
DO NOT “daisy chain” surge protectors.
DO NOT use with any aquarium equipment.
DO NOT use if properly grounded outlets are not available.
between the electrical outlet and electrical service panel.
DO NOT use for medical or life support equipment. This device features an internal protection that will disconnect the surge protective component at the end of its useful life, but it will maintain unprotected power to the load.
2
3
FOR MORE INFORMATION
Visit CyberPowerSystems.com for more information regarding:
• Product information and certifications
• Product warranty
• Connected equipment guarantee
TECHNICAL SUPPORT
Visit: CyberPowerSystems.com/support
Toll-Free: 1-877-297-6937
Hours of Operation: Monday - Friday: 7:00am - 6:00pm CST
© 2021 Cyber Power Systems (USA), Inc. All rights reserved. All other trademarks are the property of their respective owners.
Cyber Power Systems (USA), Inc.
4241 12th Avenue East, Suite 400 | Shakopee, MN 55379
CyberPowerSystems.com
CONFORMANCE APPROVALS
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and o, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
K01-E000023-00
Loading...