CyberPower Systems CPS140BI User Manual

140WattACMobile PowerInverter

UserGuide

Figure1.ProductFeature

2004-5-075/front K

Out put Po wer 140 Wa tts Co ntin uous

Output Voltage 120 Volts +/- 10%

Output Frequency 60 Hz

Output Wavef orm Simulated Sine Wave

Input Voltage 10.8 to 15.8 volts

Low Voltage S hutdown 10.5 volt

Prob lem Possible Cause Sugges ted So lutions

No AC output power (Power indi cator is not illuminated)

Poor contact with lightersocket

Automotive electrical systems requires i gnition to be on.

Car s lighter socket fuse blown

Ove r-he ati ng

Vehicle s batt ery below 10. 8 volts.

Ensure t he inverter adapt er is securely plugged i nto vehicle s lighter socket. Replace t he lighter so cket if neces sary.

Turnthevehicleignitionkeytothe

Accessory position.

Check the v ehicle fuse panel and rep lace the damage d fuse.

Allow inverter to cooldown. Ensure that there is a dequate venti lation aro und the unit and load is no more than 140 watts for continuo us operation.

Unplug the inverter and charge the vehicle battery.

Short/Long Beep Your vehicle s battery input

voltage is below than 10.8 volt.

Vehicle s battery input voltage is higher t han 15.8 volt.

Inverter i s overload.

Check vehicle s battery and ensure its capacity. Cha nge vehicle s battery i f necessar y.

Check fo r your vehicle s battery manufacturer guideline.

Reduce load to 140 watts max to maintain regulatio n.

ContactScrew

Spring

ContactPin

Fuse

DecorativeRing

LighterAdapter

CPS140BI contains a fuse inside in the Lighter Adapter (see Figure 2) to protect the unit against overloading. If the inverter draws more than 140 watts, the int ernal f use may be bl own to protect the inverter, vehicle battery and the connected equipment. To replace the fuse, please fol low the instruction below:

1. Unplug t he inverter f rom the power source.

2. Remove the Contact Screw f rom the Lighter Adapter.

3. Replace the 15 ampere fuse.

4. Reassemble t he fuse, contact pin and contact screw caref ully.

5. Ensure all pieces showed i n Figure 2 are inst alled i n the sequence shown.

*Note: For in-warranty units, the replacement fuse can be obtained from CyberPower

Technical Support. For out-of-warranty units, the replacement 15 ampere fuse can be obtained from most electronic supply retailers.

WARRANTY RETURN

Cyber Power Systems, Inc.

5555 12th Ave nue East, S uite 110, Shakopee , MN 55379, U.S.A.

TEL: (952) 403-9500 FAX: (952) 403 -0009 Toll-Free: (877) 2 97-6937 E-mail: sales@cyberpo wersystems.com

Web: www.cyberpowersystems.com

Ent ire co nte nts c opyrig ht2004 Cyb er Power Sys tems, Inc.

K01-BT14000

2004-5-075/back K