CyberPower CPBC6200AC User Manual

USB BATTERY PACK

USER GUIDE

Model: CPBC5200AC Series

INTRODUCTION

The USB Battery Pack (CPBC5200AC Series) is a high
capacity rechargeable lithium battery designed for
powering up to two mobile devices such as phones, MP3
players, tablets, and handheld gaming devices while away
from other power sources

FEATURES

- Compact and portable design

- Dual output

- Built in AC plug

- Battery life indicator

PRODUCT VIEW:

5

1

2

3

4

ITEMNO. DESCRIPTION

1

Power on/ LED Indicator Switch

2

Power Off

LED Battery Life lndicator

3

USB Output Port 1*

4

USB Output Port 2

5

AC Input Plug

*Charge tablets and Apple devices through USB Output Port 1 to achieve fast charging.

LED INDICATOR

CONDITIONNO. LED INDICATION

Battery Life Indicator

1

Overload

2

Low Battery

3

Press the button
Press and hold for 3 seconds
As the “LED INDICATOR”
table showing

5V/ 2.1A (Max.) USB output

AC 100~240V, 50/60Hz, 0.4A

Four LEDs represent 25%,
50%, 75% and 100% battery
life from left to right side.
All four LEDs flash simultaneously.
The first LED light flashes rapidly.

Note:

1. The LED indicator will automatically switch off 5 seconds
after pressing the button.

2. When the battery pack is connected to the power, the LED
indicator will light indicating the charging status. Press the
button to switch off the indicator and press the button again
to switch it back on.

PACKAGE CONTENTS

• USB Battery Pack (CPBC5200AC Series)

• User Guide

SPECIFICATIONS

Battery Capacity: 5200mA
Rated Input: AC 100~240V, 50/60Hz 0.4A
Rated Output: DC 5V 2.1A (Max.)
PC Charging time: ~6 Hours
Dimension: 4.26x2.2x0.96 inch
Weight: 5.93 oz
Environment:

Storage: 14 to 122°F (-10 to 50°C)
Operation: 32 to 104˚F (0 to 40˚C)

SUGGESTED - PRIOR TO FIRST USE:
It is recommended that you charge
your CPBC5200AC Series battery pack for
10 hours to insure a full charge.

CHARGING THE BATTERY PACK

Charge the USB Battery Pack by putting the plug into an AC
socket. When charging the battery pack, the LED indicator will
light up automatically. Press the button to turn it off and press
it again to switch the LED indicator on. Recharge the
CPBC5200AC Series every 3 months when not in use to
maintain peak battery performance. The battery capacity may
decline after 300 charging cycles.

CHARGING THE
POWER PACK

POWER

PAD

YOUR DEVICES

TROUBLE SHOOTING

Problem Possible Cause Solution

USB Battery
Pack does
not power
the device

1.The device is drawing
too much power.

2.The battery is out
of power

Check the power specification
of the device before charging
with the CPBC5200AC Series.

Charge the battery pack.

Problem Possible Cause Solution

USB Battery
pack does
not recharge

1.Incorrect connection
between charger and
USB Battery Pack.

2.No power from the
source.

Re-attach the USB connector
to the socket.

Check that power is provided

SAFETY PRECAUTION

Before using the USB Battery Pack, please read the following
warnings carefully. Use the product according to the
procedures described in this manual. Failure to follow these
safety precautions may result in fire, explosion, electrical shock
or other dangers

1. Store between 14 to 122°F (-10 to 50°C).Operate between
32 to 104°F(0 to 40°C).

2. Do not immerse this product in water or other liquids, as
such use may result in fire or electrical shock. If water or
other liquids enter the battery interior, unplug the product
immediately from any attached power source or device.

3. Do not use this product with wet hands. Moisture in or on
this product may result in electrical shock.

4. Store this product in a cool and dry environment when not in use.

5. Do not puncture this product. Puncturing the battery may
cause the release of harmful substances.

6. It is normal for the USB Battery Pack to become warm
during charging.

7. Ensure that all users read these warnings and instructions
before using.

8. Please recycle USB Battery Pack in accordance with local
environmental laws and regulations

9. Do not dismantle, open or shred secondary cells or batteries.

10. Do not expose cells or batteries to heat or fire. Avoid storage
in direct sunlight.

11. Do not short-circuit a cell or a battery. Do not store cells or
batteries haphazardly in a box or drawer where they may
short-circuit each other or be short-circuited by other metal
objects.

12. Do not remove a cell or battery from its original packaging
until required for use.

13. Do not subject cells or batteries to mechanical shock.

14. In the event of a cell leaking, do not allow the liquid to come
in contact with the skin or eyes. If contact has been made,
wash the affected area with copious amounts of water and
seek medical advice.

15. Do not use any charger other than that specifically provided
for use with the equipment.

16. Observe the plus (+) and minus (–) marks on the cell, battery
and equipment and ensure correct use.

17. Do not use any cell or battery which is not designed for use
with the equipment.

18. Do not mix cells of different manufacture, capacity, size or
type within a device.

19. Keep cells and batteries out of the reach of children.

20. Seek medical advice immediately if a cell or a battery has
been swallowed.

21. Always purchase the correct cell or battery for the equipment.

22. Keep cells and batteries clean and dry.

23. Wipe the cell or battery terminals with a clean dry cloth if
they become dirty.

24. Secondary cells and batteries need to be charged before
use. Always use the correct charger and refer to the
manufacturer’s instructions or equipment manual for proper
charging instructions.

25. Do not leave a battery on prolonged charge when not in use.

26. After extended periods of storage, it may be necessary to
charge and discharge the cells or batteries several times to

obtain maximum performance.

27. Secondary cells and batteries give their best performance
when they are operated at normal room temperature (20
°C ± 5 °C).

28. Retain the original product literature for future reference.

29. Use only the cell or battery in the application for which it
was intended.

30. When possible, remove the battery from the equipment
when not in use.

31. Dispose of properly.

LEGAL NOTICES
FCC Part 15

This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency
energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:

• Reorient or relocate the receiving antenna.

– Increase the separation between the equipment

and receiver.

– Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV
technician for help.

If the LED indicator extinguishes automatically during the
charging process, press the button to revert.

FCC WARNING

Changes or modifications not expressly approved by the
party responsible for compliance with the FCC Rules could
void the user’s authority to operate this equipment.

LIMITED PRODUCT WARRANTY

CyberPower offers limited product warranty for the hardware
of the USB Battery Pack and the product is free from material
and manufacturing defects for one year. A reasonable
purchase proof with date must be provided when submission.
CyberPower's sole responsibility is to repair or replace the
product if a material or manufacturing defect results in
product failure during its normal use. The warranty is void if
the product is damaged due to abuse, alteration, misuse,
negligence, incorrect voltage supply, air/water pollution,
accidents and natural disasters.

CyberPower Systems (USA), Inc.

4241 12th Avenue East, Suite 400, Shakopee, MN 55379, U.S.A.
TEL: [phone] Toll-Free: [phone]
FAX: [phone] E-mail: [e-mail]

CPSww.com

© 2013 CyberPower Systems, Inc.

All rights reserved. Reproduction in whole or in part without permission is prohibited.

K09-0000172-00