Cwr CWR-DC10CT Operating Instructions
CWR’S
CERAMIC + FLUORIDE & HEAVY METAL
REMOVAL WATER FILTER
MODEL # CWR-DC10CT
Counter Top Model
Operating
Instructions
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Thank you for purchasing the CWR’s Ceramic + Fluoride + Heavy Metal
Removal Water Filter . The Filter is designed to be a free - standing unit
positioned next to the sink and to be used with COLD water only.
1. Open the box labeled “Ceramic Filter”. Open the unit carefully
by unscrewing the housing sump from the base. With clean
hands, rinse the white ceramic filter under cold water to remove
any loose ceramic dust. Make sure the Rubber O-Ring is seated
properly into the housing
Diag 1
(Diag 1).
Base Opening “hole”
Ceramic Filter “hole”
O-Ring
Replace and screw the sump up into the base,
make sure the opening or hole in the ceramic
Housing
Sump
filter faces towards the base, otherwise you
will not get proper water flow.
2. Open the 2nd box labeled “Fluoride Filter”. T ighten base to the
housing sump. The fluoride filter is already seated properly.
3. Locate the small plastic bag. Remove the “3 inch connector
tube” and push connector firmly into base opening of fluoride
filter housing as far as it will go. Then push the other end of the
connector tube into the opening on the base of the ceramic
housing. Push two housings together
4. Unscrew the end piece (aerator) of your faucet. This may require use of
pliers. There should be male threads visible (threading on the outside-see
seperate “Diverter Sheet”). Screw ring of diverter valve
Push in
connector
Spigot
(see Diag 2 & 3).
Ceramic
Filter
Fluoride
+
Heavy
Metal
Filter
Diag 3
Limited One Year Warranty
The Manufacturer warrants this product, to original purchase, for one year from
purchase date to be free of defects in material and workmanship.
Should a defect be discovered within one year of date of purchase, the Manufacturer agrees to repair or replace the defective part at no charge other than handling and return freight charges. The customer service department at CWR,
must be contacted prior to any action in the event it is possible to correct the
defect wihout returning the unit. All authorized product returns must be returned
with all shipping charges prepaid, accompanied by proof of purchase and letter
explaining unit problem to CWR.
This warranty does not appy to any unit that has been tampered with, nor to
damages incurred through negligence in use, faulty packing, or mishandling in
transit by any common carrier. Your remedy does not include cost of inconvenience or damage due to product failure. The Manufacturer liabilities for damages
to you for any costs whatsoever arising out of this statement of limited warranty
shall be limited to the amount paid for this product at the time of original purchase,
and The Manufacturer shall not be liable for any direct, indirect, consequential or
incidental damages arising out of the use of inability to use this product.
The Manufacturer does not authorize any person or representative to assmue or
grant any other warranty obligation with the sale of this product.
The Manufacturer limited warranty is valid only if you retain proof of purchase from
CWR, Environmental or an Authorized Ret ail Dealer for this product. If you purchase
this product from any other source, your purchase is “AS IS,” which means The
7
Manufacturer grants you no warranty, and that you, not the Manufacturer assumes
the entire risk of the quality and performance of this product, including the entire cost
of any necessary servicing or repairs of any defects. This warranty gives you specific
legal rights; you may also have other rights, which vary state to state.
T o facilitate warranty service request please: Keep dated sales receipt
6
FOR SERVICE or PARTS:
1-800-444-3563
5 6
For Service call:
1-800-444-3563
Diag 2
Connector Tube
1
Divertor Tubing
allwk\gary null\GN-DC4CT instructions 2012
For Replacment Filters call your dealer:
6
Loading...