English
Dos and Don'ts
1. Please read the leaflet carefully.
2. Please pay attention to all the warnings.
3.
Please follow the illustrations provided by the manufacturer for proper usage.
4.
Please only use the correct accessory or part appointed by the manufacturer.
5.
Please do not expose the device to excessive water or humid environments
6. Please do not place the device near an open fire source.
7. Please do not throw or physically abuse the device.
8. Please do not allow a child to use the device alone.
Warning
It is hazardous to execute some functions and/or operations not stated
in this manual. Avoid exposing the speaker to overheated conditions. To
prevent any damage, avoid putting the speaker near the cooler, around
heaters, under direct sunshine or near water and humid environments.
Advice
Remove the device from the packaging carefully and preserve the
packaging in good condition for limited warranty purposes and product RMA.
Please avoid using the hand-free calling function in the state of charging.
For your safety
-
When moving the device after charging make sure the plug/s (micro-usb or
mains)
has been properly unplugged.
-
It is prohibited to unplug the plug by dragging the power cable.
-
It is prohibited to operate the plug with the wet hands since this may lead to fire
or electric shock.
- It is prohibited to disassemble the outer casing.
If repairs are required, make sure it is serviced by certified technicians
-
recommended by the manufacturer and/or certified
limited warranty could be null and void.
-
It is prohibited to wring or squeeze the power cable. It is necessary to make
sure the plug or the power cable to be replaced and/or maintained
meet the requirements requested by the manufacturer.
- Unplug the device from the mains power during thunder and lighting
conditions or when not in use for long periods .
- Different regions may require different power plugs and adapters due
to varying regional voltage and safty requirements.
agent. If not, your
- Please unplug the plug from the socket if the power is to be turned off
completely.
Warning: Just a reminder. Any alteration or revision without
manufacturer's approval may lead to malfunction.
Notice: It is hazardous to replace the battery cell in the speaker
since this may cause explosion. Please dispose of the used battery
cell and device properly according to the legal terms of the your
regional requirements.
FCC Interference Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
The product comply with the US portable RF exposure limit set forth
for an uncontrolled environment and are safe for intended operation
as described in this manual. The further RF exposure reduction can be
achieved if the product can be kept as far as possible from the user body
or set the device to lower output power if such function is available.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Industry Canada statement
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Radiation Exposure Statement:
The product comply with the Canada portable RF exposure limit set forth
for an uncontrolled environment and are safe for intended operation
as described in this manual. The further RF exposure reduction can be
achieved if the product can be kept as far as possible from the user body
or set the device to lower output power if such function is available.
Déclaration d'exposition aux radiations:
Le produit est conforme aux limites d'exposition pour les appareils
portables RF pour les Etats-Unis et le Canada établies pour un
environnement non contrôlé. Le produit est sûr pour un fonctionnement
tel que décrit dans ce manuel. La réduction aux expositions RF peut être
augmentée si l'appareil peut être conservé aussi loin que possible du
corps de l'utilisateur ou que le dispositif est réglé sur la puissance de
sortie la plus faible si une telle fonction est disponible.
CAN ICES-3 (B)/NMB-3(B)
The Regulations on Low-power Radio-frequency
Electronic Devices (NCC)
Article 12: Regarding the low-power radio-frequency electronic devices
with the model qualification, any company, store or user may not do the
followings willfully without permit: frequency altered, power amplified,
or qualities and capacities designed originally changed.
Article 14: The low-power radio-frequency electronic device(s) in use
may not affect the flight safety and interfere with legal communications.
The user shall stop using the device(s) immediately once the interference
is identified and may not use it (them) unless the interference is
unidentified due to improvement. The said legal communications refer