Cutter SKS-10 Instruction Manual

1.

Insert
front.

2.

A suitable knife

CD

micro gauge into hole

Operation

holder

Sheet

CD

-1

can

for

Knife

and

fasten it with knob ®-1

be

installed

Sharpener

on

the

gauge

from

bracket

the

and

fastened

3.

Put

either lower
wing nut. Allow the cutting edge
stone.

4.

Switch

Hold

5.
motion

6.

Rotat
edge
edge will get

7. A new

by

the knob

or

on

the

sharpener,

the

handle

allovving the knife-edge to swing freely

e the micro gauge

of

the

stone. Swing

sharpened

and

sharp

CD-2

upper

CD-3

edge

knife

and

and

swing the knife

knob

the

.

can

on

the knife

of

the

the stone ~ rotates.

CD-4

knife

easily be accomplished by slightly

to

push

holder

holder CD-1

knife to come close to

holder

the

continuously

with a

yet

close to

knife-edge closer

and

back

the

and

the

fasten the

the

& forth

stone.

to

the

knife-

rotating

the micro gauge closer to the stone.