Cutler Hammer, Div of Eaton Corp PSG240F24RM Data Sheet

DATASHEET - PSG240F24RM
Power supply unit, 3-phase, 400-500VAC/24VDC, 10A
Part no. PSG240F24RM Catalog No. 172884 Alternate Catalog
PSG240F24RM No. EL-Nummer
0004560882 (Norway)
Delivery program
Product range Power supplies PSG
Subrange power supply unit
Description Power Boost via 1.5-fold rated operational current for 5 s
Phases Three-phase
Input voltage range 320 - 600 V AC
Nominal input voltage 3 x 400 - 500 V AC
Rated output voltage 24 V DC (± 2%)
Rated output current A 10
Setting range for the output voltage 24 - 28 V DC
Rated output power W 240
PELV (EN 60204), SELV (EN 60950)
(450 - 800 V DC)
Technical data
Input characteristics
Nominal input voltage 3 x 400 - 500 V AC
Input voltage range V 3 x 320 - 600 V AC
Supply frequency
Rated value Hz 50/60
Range Hz 47 - 63
Nominal current I
Inrush current limitation I²t (+25 °C) A Voltage source up to 3 KVA: < 40 A with 3x 400 V AC & 3x 500 V AC
Mains buffering at nominal load ms
Mains failure bridging ms > 20 with 3x 400 V AC
Run-up time after mains voltage applied ms < 1000
Internal input fuse (device protection, not accessible) T3.15 AH/500 V, 600 V
Back-up fuse 3 x 6, 10, 16 A (recommended)
Tripping characteristic B
Leakage Current < 3.5 mA at 500 V AC
Short-term interruption 100% voltage dip, 1 cycle (20 ms at 50 Hz), automatic start
DC duty L1 +, L2 –, L3 nc, PE #
n
Output characteristics
Rated output power W 240
Rated output voltage 24 V DC (± 2%)
Tolerance ±2 %
Setting range for the output voltage 24 - 28 V DC
Nominal current A 10
Derating from T
Capacitive load starting Max 10000 µF
Heat dissipation W 26.7
> +50 °C Vertical:
amb
2 x 360 - 600 V AC 450 - 800 V DC
A < 0.75 bei 3 x 400 V AC
< 0.65 bei 3 x 500 V AC
Voltage source up to 18 KVA: < 60 A with 3x 400 V AC & 3x 500 V AC
>40 with 3x 500 V AC
L1 +, L2 nc, L3 –, PE #
> 50 °C (2.5% / °C) > 70 °C (5% / °C) Horizontal: > 40 °C (2.5% / °C) > 60 °C (5% / °C)
08/30/2019 Eaton 172884 ED2019 V58.0 EN 1 / 4
Efficiency % > 90 with 3 x 400 V AC & 3 x 500 V AC
Residual ripple and switching peaks < 50 mVpp / < 150 mVpp
Can be switched in parallel for redundancy, with O ring diode (PSG480R24RM/PSG960R24RM)
General characteristics
Housing Aluminium
Status indication green LED for "DC OK"
MTBF (mean time between failures) > 300,000 h
Height mm 121
Width mm 70
Depth mm 117.3
Weight kg 0.89
Terminations Screw connection
Stripping length mm 7
Terminal capacity
flexible with ferrules/solid
Tightening torque Nm Primary side: 0.9
Ambient air temperature range °C
Operation °C -25 - +80
Storage, transport ϑ °C
Storage ϑ °C -25 - +85
damp heat < 95 % relative humidity at +25 °C, no condensation
Vibrations (IEC/EN 60068-2-6) 10 - 500 Hz at 30 m/s² (3 G max ) for 60 min. in X-axis, Y-axis, Z-axis directions
Mechanical shock resistance (IEC 60068-2-27) 30 g (300 m/s²) in all directions
Pollution degree 2
Climatic class (IEC) 3K3 according to EN 60721
2
Primary side: 0.82 - 3.3 mm² (18 - 12 AWG)
mm
Secondary side: 1.3 - 3.3 mm² (16 - 12 AWG)
Secondary side: 0.6
Safety and safety features
Transient overvoltage protection Varistor
Current limitation at short-circuit I
Overvoltage protection Yes, against internal overvoltage
Insulation voltage
Input/Output 4 kV AC
Input/PE 2 kV AC
Output/PE 1.5 kV AC
Degree of Protection IP20
Protection class Class I with PE connection
= 150 % der max. Ausgangsleistung
Überstrom
Standards
Electrical equipment of machines: IEC60204-1 (Overvoltage category III) Equipping power installations with electronic apparatus: EN 50178/IEC 62103 Safety extra-low voltage: PELV (EN 60204), SELV (EN 60950) Protection against electric shock: DIN 57100-410 CE: according to EMC Directive 2014/30/EU and Low Voltage Directive 2014/35/EU RoHS-compliant: RoHS Directive 2011/65/EU ITE: EN 55022, EN 61000-3-2, EN 61000-3-3, EN 55024 Industrial: EN 55011 Mains harmonics limitation: EN 601000-3-2 Electrical Safety (of IT equipment) : SIQ to EN60950-1, UL/c-UL recognized to UL 60950-1, CSA C22.2 No. 60950-1, CB scheme to IEC 60950-1 UL508 Class2: UL/c-UL recognized to UL1310 and CSA C22.2 No. 223 | Component power supply unit for general use: EN61204-3
Approvals EAC
Design verification as per IEC/EN 61439
Technical data for design verification
Rated operational current for specified heat dissipation I
Heat dissipation per pole, current-dependent P
Equipment heat dissipation, current-dependent P
Static heat dissipation, non-current-dependent P
Heat dissipation capacity P
Operating ambient temperature min. °C -25
08/30/2019 Eaton 172884 ED2019 V58.0 EN 2 / 4
n
vid
vid
vs
diss
A 0
W 0
W 0
W 26.7
W 0
Operating ambient temperature max. °C 80
IEC/EN 61439 design verification
10.2 Strength of materials and parts
10.2.2 Corrosion resistance Meets the product standard's requirements.
10.2.3.1 Verification of thermal stability of enclosures Meets the product standard's requirements.
10.2.3.2 Verification of resistance of insulating materials to normal heat Meets the product standard's requirements.
10.2.3.3 Verification of resistance of insulating materials to abnormal heat and fire due to internal electric effects
10.2.4 Resistance to ultra-violet (UV) radiation Meets the product standard's requirements.
10.2.5 Lifting Does not apply, since the entire switchgear needs to be evaluated.
10.2.6 Mechanical impact Does not apply, since the entire switchgear needs to be evaluated.
10.2.7 Inscriptions Meets the product standard's requirements.
10.3 Degree of protection of ASSEMBLIES Meets the product standard's requirements.
10.4 Clearances and creepage distances Meets the product standard's requirements.
10.5 Protection against electric shock Does not apply, since the entire switchgear needs to be evaluated.
10.6 Incorporation of switching devices and components Does not apply, since the entire switchgear needs to be evaluated.
10.7 Internal electrical circuits and connections Is the panel builder's responsibility.
10.8 Connections for external conductors Is the panel builder's responsibility.
10.9 Insulation properties
10.9.2 Power-frequency electric strength Is the panel builder's responsibility.
10.9.3 Impulse withstand voltage Is the panel builder's responsibility.
10.9.4 Testing of enclosures made of insulating material Is the panel builder's responsibility.
10.10 Temperature rise The panel builder is responsible for the temperature rise calculation. Eaton will
10.11 Short-circuit rating Is the panel builder's responsibility.
10.12 Electromagnetic compatibility Is the panel builder's responsibility.
10.13 Mechanical function The device meets the requirements, provided the information in the instruction
Meets the product standard's requirements.
provide heat dissipation data for the devices.
leaflet (IL) is observed.
Technical data ETIM 7.0
Low-voltage industrial components (EG000017) / DC-power supply (EC002540)
Electric engineering, automation, process control engineering / Power supply devices / Power supply device / Continuous current supply (ecl@ss10.0.1-27-04-07-01 [AFX040003])
Voltage type of supply voltage AC
1st secondary output voltage V 24 - 28
2nd secondary output voltage V 0 - 0
3rd secondary output voltage V 0 - 0
Max. output current 1 A 10
Max. output current 2 A 0
Max. output current 3 A 0
Secondary voltage adjustable Yes
Nominal value output voltage 1 V 24
Nominal value output voltage 2 V 0
Nominal value output voltage 3 V 0
Nominal value output current 1 A 10
Nominal value output current 2 A 0
Nominal value output current 3 A 0
Short-circuit-proof Yes
Rated supply voltage at AC 50 Hz V 320 - 600
Rated supply voltage at AC 60 Hz V 320 - 600
Rated supply voltage at DC V 0 - 0
Output voltage stabilized Yes
Power consumption VA 300
Power output W 240
Stabilized Yes
Type of electric connection Screw connection
Rail mounting possible Yes
08/30/2019 Eaton 172884 ED2019 V58.0 EN 3 / 4
Wall mounting possible No
Modular version Yes
Width in number of modular spacings 0
Built-in width mm 70
Built-in height mm 121
Direct mounting possible No
Width mm 70
Height mm 121
Depth mm 117.3
Suitable for safety functions No
SIL according to IEC 61508 None
Performance level acc. EN ISO 13849-1 None
Degree of protection (IP) IP20
Degree of protection (NEMA) 1
Dimensions
08/30/2019 4 / 4
Loading...