Cusack Music Screamer Owner's Manual

LEVEL - This is the overall level of the af-
fected signal. Adjust this for the correct sound level between off and on.
Tone - Controls overall tone of the pedal.
Drive - All the way counter clockwise is no
gain, all the way clockwise is about twice
Status LED (Red/Green) - When the effect is on
the LED is Red. When battery voltage is below ~7.5V, the LED will blink a few times when the pedal is engaged. By default the LED is Green when by­passed. To have the LED off in bypass HOLD the By­pass Switch for several seconds until the LED Blinks.
Hold again to turn the LED back on in Bypass.
the gain of a typical Overdrive pedal.
OUT - Output of the pedal. Plug this either into your amp or into any other ef-
fects you want after this effect.
Bypass Switch - Kick the switch to change from
effect off
.
DC Power Jack - Used
to power your pedal from a DC supply. This has the same pin-out as the standard pedal supplies, tip is ground, sleeve is 9V. Use a filtered supply, especially on high gain over­drive and distortion pedals, since they tend to
effect on
to
Clip Mode Toggle - Select the type of Clipping
Diodes. To the Left is “Stock”, to the right is
“Crushed”, and in the middle is “LED” (Asymmetrical
LED clipping). Different diodes cause the overall
level to change, so you may have to adjust
the level after moving the Clip
Mode Toggle.
Clip LED -
This is the
LED above the Toggle
Switch. When in LED Clip
Mode, this LED will follow
your guitar playing. The
brightness will vary depending
on guitar pickups and Drive set-
ting, and does not light up at low
gain settings. If you jam the front
end with another high gain pedal, you
can use the Clip-O-Meter to tune your
guitar. Hit your 5th fret and next open;
Tune until the Clip-O-Meter stops blinking. A
great trick to impress your friends with!
amplify power supply noise.
Power Consumption - ~8mA.
Updated 7/16/10
www.cusackeffects.com 494 Lincoln Ave, STE 10, Holland, MI 49423 (616)546-8888
Loading...