Cusack Music Scream Owner's Manual

LEVEL - This is the overall level of the af-

fected signal. Adjust this for the correct

Power LED (Green) - When the effect is pow­ered the LED is on.

sound level between off and on.

TONE - Controls overall tone of the pedal.

DRIVE - All the way counter clockwise is no

gain, all the way clockwise is about twice
the gain of a typical Overdrive pedal.

IN—Guitar Input to the pedal or connect to
a Loop Send on your Pedal Board Tamer.

OUT - Output of the pedal. Plug this either
into your amp or connect to the Loop Re-

turn on your Pedal Board Tamer.

DC Power Jack - Used to power your pedal
from a DC supply. This has the same pin-

out as the standard pedal supplies, tip is
ground, sleeve is 9V. Use a filtered supply, espe­cially on high gain overdrive and distortion pedals,

Clip Mode Toggle - Select the type of Clipping

Diodes. To the Left is “Stock”, to the right is

“Crushed”, and in the middle is “LED” (Asymmetrical

LED clipping). Different diodes cause the overall
level to change, so you may have to adjust the level

after moving the Clip Mode Toggle.

since they tend to amplify power supply noise.

Power Consumption - ~8mA.

Updated 7/16/10

www.cusackeffects.com 494 Lincoln Ave, STE 10, Holland, MI 49423 [phone]