Curtis SB350BT User Manual

2.0CH Wireless Soundbar

PLEASE READ BEFORE OPERATING THIS EQUIPMENT.

Model No.:SB350BT

WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK HAZARD. DO NOT

EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

WARNING: REMOVE THE BATTERY FROM REMOTE CONTROL IF WILL NOT

BE IN USE FOR A LONG PERIOD. DO NOT PLACE BATTERY IN TRASH.

PLEASE RECYCLE OR MANAGE AS HAZARDOUS WASTE.

Some of the following information may not apply to your particular product;

however, as with any electronic product, precautions should be observed during

handling and use.

� Read these instructions.

� Keep these instructions.

� Heed all warnings.

� Follow all instructions.

� Do not use this apparatus near water.

� Clean only with dry cloth.

� Do not block any ventilation openings. Install in accordance with the

manufacturer’s instructions.

� Do not install near any heat sources such as radiators, heat registers,

stoves, or others apparatus (including amplifiers) that produce heat.

1

Do not defeat the safety purpose of the polarized or grounding plug. A polarized

plug has two blades with one wider than the other. A grounding plug has two

blades and a third grounding prong. The wide blade or the third prong is

provided for your safety. If the provided plug does not fit into your outlet,

consult an electrician for replacement of the obsolete outlet.

� Protect the power cord from being walked on or pinched particularly at

plugs, convenience receptacles, and point where they exit from the apparatus.

� Only use attachments/accessories specified by the manufactured by the

manufacturer.

� Use only with the cart, stand, tripod, bracket, or table specified by the

manufacturer, or sold with the apparatus. When a cart is used, use caution

when moving the cart/apparatus combination to avoid injury from tip-over.

]

Portable Cart Warning

Unplug this apparatus during lightning storms or when unused for long periods

of time.

� Refer all servicing to qualified service personnel. Servicing is required

when the apparatus has been damaged in any way, such as power-supply cord

or plug is damaged, liquid has been spilled or objects have fallen into the

apparatus, the apparatus has been exposed to rain or moisture has been

exposed to rain or moisture, does not operate normally, or has been dropped.

� WARNING: Please refer the information on exterior bottom (enclosure)

for electrical and safety information before installing or operating the apparatus.

2

WARNING: To reduce the risk of fire or electric shock, do not expose this

apparatus to rain or moisture. The apparatus shall not be exposed to dripping

or splashing and that objects filledwith liquids, such as vases, shall not be

placed on apparatus.

� WARNING: The battery (battery or batteries or battery pack) shall not

be exposed to excessive

heat such as sunshine, fire or the like.

� WARNING: The main plug is used as disconnect device, the disconnect

device shall remain readily operable.

ADDITIONAL SAFETY INFORMATION

� Apparatus shall not be exposed to dripping or splashing and no objects

filled with liquids, such as vases. Should be placed on the apparatus.

� Always leave sufficient space around the product for ventilation. Do not

place product in or on a bed, rug, or in a bookcase or cabinet that may prevent

air flow through vent openings.

� Do not place lighted candles, cigarettes, cigars, etc. on the product.

� Care should be taken so that objects do not fall into the product.

� Do not attempt to disassemble the cabinet. This product does not

contain customer serviceable components.

The marking information is located at the rear panel of apparatus.

�

� The ventilation should not be impeded by covering the ventilation

openings with items such as newspaper, table-cloths ,curtains etc.

� No naked flame sources such as lighted candles should be placed on

the apparatus.

� Only use this in moderate climates.

3

IMPORTANT BATTERY INFORMATION

Warning: Your product contains a battery and charging system which is

designed to work in temperatures that do not exceed 50℃(122℉).Leaving this

product in a closed automobile or the trunk of an automobile where

temperatures may result in permanent battery damage, fire, or explosion.

Please remove your product from the automobile when you exit, do not place

your product in the trunk of your automobile, and do not leave your product in

any location where temperatures may exceed 50℃.

ECOLOGY

Your product must be disposed of properly according to local laws and

regulations. Because this product contains a battery, the product must be

disposed of separately from the household waste.

PRECAUTIONS FOR THE UNIT

� Do not use the unit immediately after transportation from a cold place to

a warm place; condensation problems may result.

� Do not store the unit near fire, places with high temperature or in direct

sunlight. Exposure to direct sunlight or extreme heat (such as inside a parked

car) may cause damage or malfunction.

� Clean the unit with a soft cloth or a damp chamois leather. Never use

solvents.

� The unit must only be opened by qualified personnel.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference.

4

(2) this device must accept any interference received, including interference

that may cause undesired operation.

NOTE : This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

CAUTION:　Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment.

INDUSTRY CANADA REGULATORY INFORMATION

This device complies with Industry Canada license-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.

5

CAUTION:　Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment.

Industry Canada Regulatory Information

CAN ICES-3(B)/NMB-3(B)

Controls

1. Remote Control Sensor

2. - Button

Press to decrease the volume level.

1

2 3 4 5

10

6 7 8 9

3. +Button

Press to increase the volume level.

4. Button

Press this button to turn ON or press and hold to Standby mode.

Short press this button to select different play mode during power on.

6

5. LED Status Indicator

Red=Standby mode

Blue=Bluetooth mode

Green=AUX/RCA input mode

6. RCA (L, R) Socket

7. 3.5mm Aux-in Socket

8. Main Power ON/OFF Switch

9. Power Cord

10. USB Port (only for charging)

REMOTE CONTROL

1

MODE

2

3

4

5

VOL+

6

7

VOL-

1. Power Button (On/Standby)

2. MODE button (Bluetooth/AUX)

3. Play/Pause button

4. Next track

5. Previous track

6. Vol + Button

7. Vol - Button:

7

Before using the speaker

Plug the power cord to a wall outlet (120V～60Hz). Status indicator will be red .

3.5mm AUX/RCA inputs operation

1. Ensure that the unit is well connected to the TV or other audio device via

the accompanied 3.5mm-RCA cable.

2. While in Power On mode, press the button on the main unit

repeatedly or press the AUX/RCA button on remote control to select the

AUX/RCA input mode.

3. Operate your audio device directly for playback features.

4. Press “▲” / “ ” button on remote control or tap the“+”/ “-” button on the

main unit to raise/lower the volume level.

Note: If the 3.5mm AUX-IN socket and the RCA socket are both connected, the

3.5mm AUX input mode will be the default choice. To select the RCA input

mode, make sure the 3.5mm Aux in socket is not plugged in

Connect and use the speaker (Bluetooth mode)

1. Power on the speaker.

2. Change to Bluetooth mode. Status indicator will blink blue.

3. On your Bluetooth device, turn on Bluetooth and scan for device in its

Bluetooth menu. When “SB350BT” appears on the device list of your Bluetooth

device, select and connect .

4. The status indicator will change to solid blue after Bluetooth pairing

established.

8

Specification

Input voltage: 120V～60Hz

USB output: DC 5V 1A

Output power (RMS): 15W+15W

Power Consumption: 35W

Standby power Consumption: ≤0.5W

Transmission distance: up to 30ft (10m)

Working temperature: 0℃-35℃

Bluetooth version: V2.1+EDR

Supported protocol: A2DP, AVRCP

Frequency response: 60Hz-18KHz@-10dB

Signal noise ratio: 50dB

Dimension: 33.10x4.37x2.17in (840x111x55mm)

Weight: 95 oz (2.7Kg)

Remote control

Use battery: 2pcsxAAA

Working current: 8mA

Sleep mode current: 8μA

Operation distance:up to 10ft (3m)

Operation angel: ±30º

9

Increase the volume on the
audio source.

device

speaker

window

Trouble shooting

Problem Cause Solution

No audio signal
via the
Bluetooth
connection

Speaker cannot
be connected

Poor sound
quality from a
Bluetooth

®

Speaker is not
paired to the audio
source.

Volume is setting
too low

Pairing does not
work

Audio source is
switched off

Bluetooth is
switched off at the
audio source.
Existing Bluetooth
connection is not
unpaired normally
Bluetooth device
is almost out of
range of the

Check whether a connection
exists. If necessary, pair the
speaker again to the audio source.

speaker
Increase the volume on the the

Check whether the audio source
supports the A2DP protocol

Switch on the audio source

Switch on the Bluetooth function in
the audio source.

Unpaired current Bluetooth
connection and pair again.

Move your Bluetooth device
closer to this unit

Remote control
is not
functioning
properly.

Low battery.

Remote Control
is not pointed
toward the IR

Replace the battery with correct
type AAA

Point the Remote Control toward
the unit IR window, use within 10
feet of the unit.